How To Fix Repair a Stuck Locked Jammed Seat Belt Pretensioner
Вставка
- Опубліковано 5 лис 2016
- A video on how to fix stuck, locked & jammed seat belt pretensioners after accident. All seat belts have a gas charge or a pyrotechnic device in them that goes off during a crash, locking the seatbelt mechanism. Once this gas charge goes off, the seat belt will not work again during an accident. Once fired, your seat belt may be jammed, locked, not retracting, stuck, making weird rattling noises and your airbag light may be on. In rare situations, the seat belt will work fine but still be bad. If you suspect that your seat belt is blown or the gas charge has set off, you will need to remove it and then follow the instructions on properly testing it for the Ohms resistance. If the seat belt is good, you will have a 2-3 Ohms reading. If the seat belt is bad, the Ohms reading would either jump around rapidly or read 0. This means that your locked, jammed, stuck or blown seat belt is bad and will not work again! At this point what I do is send it out to www.safetyrestore.com/ to get it repaired. A lot cheaper than buying new from the dealer. I work with a lot of salvage cars and have been using Safety restore for a very long time, all the guys at safety restore are great and get the job done! 24 hour turnaround & lifetime warranty.
Seat belt fix is compatible with Acura, Honda, Ford, Chevy, Nissan, Toyota, Lexus, Dodge, Cadillac, Infiniti, BMW, Mercedes, VW, Subaru, Chrysler, GMC, Jeep, Hyundai, Kia, Mitsubishi and other models. - Авто та транспорт
THIS VIDEO IS AN ADVERTISEMENT, NOT A GUIDE.
Most of you probably have seatbelts stuck in reverse lock. Here's the solution:
1. Hold the seatbelt retractor between your legs in the EXACT same orientation as it is on the car (as close as you can get it)
2. Wind the seatbelt back 1/2" -3/4"
3. Gently pull the seatbelt back up, making sure that the belt exits the retractor at the same angle it would when installed on the car.
4. If it locks, back it up 1/2" - 3/4" and try again. You may have not gotten the orientation right.
5. When you pull it out all the way, use a clip to keep it from retracting back or loosely tie a knot in it to prevent it from retracting all the way again. (Obviously don't install your seatbelt with a knot in it).
There. 5 steps. I fixed 3 junkyard seatbelts this way. Was that so hard, Gavin?
I'm looking for a solution so I don't have to take the retractor out. I'm a chick. These tools confuse me. 😉
hi . if you can help me with that .I sent my seat belts already to the place and they fixed them but my question is do I need to replace the seat belt sensor the one where you hock the seat belt back its located on the driver side between the front and the rear seat
You helped a lot. Thank you
change your title ...to more like about safety seatbelts
where is the FIX not replace
It's a solution for the problem many folks have, and that is the seat belt being stuck/jammed after accident. Hope it helps someone!
another freaking sales gimmick again
You never fixed it dawmit!!'
Can you help me?
I got a salvaged car and it was in an accident no airbags deployed, maxima 07 the code is B1086 pretensioner left front (open) do I need to take this out and ship it somewhere to be fixed?
sounds like it, yeah. I recommend SafetyRestore.com
How about going to the junk yard and getting another one instead of the expense of sending off and fixing? Just a thought.
Because time is money
@@fuckjewtube69 If it saves me money my time is usually worth it.
I have a 03 durnago with a shorted seat belt. the gas charge hasn't gone off. Can I just put a 2,5 ohm resistor across both wires before the connector? to turn off the light? or solder in a good pigtail from the wreckers?
Yes
hi gavin, hows it goin? ive got a seat belt, drivers side that extends, but only to a sertain limit. now im a large guy so it extends just enough 4 me 2 b able to click it in, no more & it wont go past that point ! what do u think the trouble is with the belt?
Shii... you got me!!
Shiii me 2
2011 infinity fx35 passenger seat belt jammed
thanks for wasting my time to make a point.
Nice leather interior.
People commenting negatively here have no idea what they are talking. you cannot fix a seat belt with a blown charge at home it has to be sent out and this company is pretty good although they are the only ones I have used. Perhaps he should change his title for the more dim-witted.
You are doing advertising to the company
What do you mean the seatbelt will never work again if you unlock it and put it back in yourself? It won’t retract? Or what? I don’t really care if it doesn’t lock up when i get into a wreck. I just want the seatbelt to retract so i don’t get a seatbelt ticket when driving
No good to die.
Cassie Myers on god I was thinking the same 😂
thanks for name of company
Fucking brilliant
safety restore
Never use a multimeter to probe those wires. That can cause an unexplored charge to go off.
my seatbelt maybe got gummed up from spilt coke? it jams sometimes...?
"spilled"
you owe me 5 mins.
Over than 20 mins on the phone no body answer 1 guy company! Do fix answer phone ship the seatbelts if someone sent them by mistake what a joke
WORST COMPANY EVER! Do not use this company they are scam artist. Do yourself a favor and find another.
Useless vid
Waste of time. Straight up ad!
3:00 That's actually an open circuit read, not zero ohms (which would indicate short circuit).