Відео

Can you use anything else to pry the case apart?

As others have said, the dangers of a single dead cell are very real and likely what the BMS has picked up on. I know the Xiaomi's let you view the BMS data over bluetooth, that would be worth checking, if it has this feature. Finally, rather than upping the amps on the PSU, leave the amps low and up the voltage. Check the voltage rating on the battery and go no higher than 95% of this. If it's a 37v battery, go to 35v, that will put you at 3.5v/cell (assuming balanced!) at which point the BMS should be happy to do the rest. If it was me I'd be checking Bluetooth data, or taking the pack apart to test for dead cells... If this wasn't an option I'd be charging it outside, the risks are just too high, especially when bypassing the BMS

the problem you can have is that you have a dead cell, the bms will protect against that. if you bypass it you can over charge the other cells with the associated risks of unpleasantness. If it won't run / charge via the BMS then you have a problem either with the BMS or you have an out of spec cell that it is protecting you from.

The proper charger should have been able to take over by now. If it doesn't charge, something is VERY wrong with the pack. Charging it the way you are will not balance the cells. Not worth the risk. I would just buy another battery. Even if you do get this thing to operate somewhat, it will likely be very poor output/runtime.

Hey, questions can the ram on these be u soldered and larder modules put back in

OMG, I was about to have splash out £200 on a new box and in desperation did a bit of doctor google and came across your video, quick purchase of hard drive on Amazon for £18.99 and with your clear instructions even a girl can do it! Lost my saves channels but box working perfectly, thank you so much.

Excellent video and clear instructions, after watching this video and ordering a new drive from the Ebay link supplied (which arrived after only two days) I found it relatively easy to swap out the hard drive on my BT vision box. Once installed I needed to reset the BT vision box back to the factory settings, thanks to the clear instructions on the video this was quite easy however, I did have to follow the process a few times before the Maintenance Mode came up but once it did it was easy to follow and fully up and running in a few minutes. Thanks again.

Hi, Thanks for this really helpful, My BT box (1Tb) keeps switching off or giving a blank screen, primarily when viewing recordings although, my wife said it also happened when watching tv (which I have not seen, but I suspect it may have been pausd so then viewing from the HDD maybe? - Do you think replacing this will work or try a hard reset first and delete all recordings?

I have the same recorder you are working on now cannot get the volume on the remote up or down can you help 😭 6:05

I have a humax hdr-fox t2 what s the best make hard drive you would recomend

Thanks for the video, and the links to the parts. I might have a go at fixing mine.

Very nice tutorial, it was nicer if you filmed when you dissasemble the tablet. I have the same tablet, with the same issue with the power connector, but i want to upgrade it to usb c, when i will have the time, :) but i like the tablet it is very snappy!

Don't fit a Seagate drive as they are very poor quality and tend to fail over time. Why no static straps?

Suddenly my Humax unit stated that there were no recordings on the disc. And it refuses to record anything when programmed ...drive has failed will have it replaced. Might use and SSD unit

Hi great video, please can you help i have the same model as you,the issue is I switch it on and its constantly in a cycle of waking up and youview loading

Hi, I have that charging icon all the time and I haven't touched anything. It only changes when turned off. So I think that it's a design flaw rather that something you did wrong. About the soldering, would you change anything now that you look back?

These can be “brought”. I think you mean “bought” !!!

WOW - I have NEVER seen the top that clear. Every time I have been to the top, it was snowing and whited out, with snow falls

how do you zero the ohms setting?????

Can l ask what time of year you filmed this please.

My parents has this, rang me saying not working. Found out talktalk offered them fullfibre with eero router. Talktalk youview doesnt work with it. They failed to tell elderly parents this ... Ended contract talktalk

Hi. I've tried to replace the harddrive of my Huawei DN370t with another identical drive but it won't download the software. Have you replaced any hard drives?

Can you use an sdd?

Brilliant-couldn’t figure this out until I saw your video. I was able to use my thumbnail to prise the back off at the gap at the charging prongs 🙏

How do you know that your hard drive has failed? My box just continually tries to reboot now, but never reaches the home page. Makes a beeping noise too

I replaced all 4 caps supplied in the kit. Still there is no power. What else could be wrong. I ger power upto socket and fuse is OK.

Please show me how to undelete a recording from BT please 😭😭😭😭😭😭😭😭😭😭😭😭😭😭😭😭😭😭😭😭😢😢😢😢😢😢😢😢😢💔💔💔💔💔💔 Please please please

Very Helpful ,Thank you .

Yawn

Great video, been wanting to update 500gb to 1Tb and now sorted. Thanks again.

been using this onsite for a few weeks, all works well.

Part 2 ua-cam.com/video/2yscCgksgZc/v-deo.html

I've fixed it - part 2 coming soon

*promosm* 😑

Is there a way to disable the awful Netflix, iPlayer, itv Hub and On Demand buttons? I'm close to dismantling the remote just to cut out the buttons from the rubber pad and cover the holes with tape. I've lost count the number of times my fat fingers have pressed Netflix instead of 1. Ive disabled the internet connection on the Freesat box so I can exit the app faster but these On Demand buttons are in a prime location of a poorly designed remote. Cheers.

Hi. There are two versions of thr binatone 550 radios. The version with the time is an older modelm They do run on the same license free frequencies of PMR446. The first set is on channel 7 and the second is on channel 1. In order for all radios to communicate you have to press the menu key and the up and down arrows until they have the same channel (main digit) and subchannel (the smaller number) matched. All sets will then communicate. I do hope this helps.

Cracking video thank you, please can i ask can you add a 1TB drive if it was fitted with a 500GB originally? Thanks

Thank you! 👍👍

An update to this video: it seems better if you can use a lower power hard drive (5 volts at 0.55amps or lower seems to be the best WD & Seagate drive are OK but check the spec)

UPDATE: I WOULD SUGGEST USING A SEAGATE HARD DRIVE OR WESTERN DIGITAL AS THEY HAVE A LOWER POWER CONSUMPTION, AROUND 0.55AMP @5volts324 THEY SEEM TO HAVE LESS COMPACTIBITY ISSUES USING THE LOWER AMP

Would have been much more helpful if it had shown the prising apart of the charger aperture. Could also have commented on the ease of using a knife blade in place of the plastic too which 99% of people would try. .

Thanks for that. Is there a specifc number for the correct batteries?

First view, first like and first comment.

Cheers. You just saved me £70 for some new phones. 👍

Thanks for straightforward explanation.

Very clear. Thank you. Now I'm off to try it.......

a most helpful video

Thank you so much x

Thank you very much, I was just about to invest in a new phone.

Ty. Same as a telstra guardian. Putting the name here in case it helps people hunting for this info.