Відео

Fucking bad ASS💯🦾🦾

Bro how n the world is that belt taking that

Where can u buy it

Bro that side by side is on rubber bands

Does the primary clutch have a limiting spacer on it?

60км/ч очень мало! У меня карбюратор на 26 колесах с кофром по ровной дороге едет 92 км/ч

The fuel line is supposed to have a shroud around it after it enters the bottom of the genset

That’s insane power 💯

Good job man. How many watts is the stator?

Wher can i buy ATV flerings

Were did you find it used?

2 o-rings go on the brake cam to hopefully keep grease in and water out

Гидроудар☠️

You should be labeled a traitor to America

I have an 05 450 and after it gets warmed up and you rev it , it doesn’t wanna idle down. Or if you’re riding and hit the gas it doesn’t idle back down, it takes a while before it does. Almost like it sticks

That's my problem. i live in AZ, and i ran mine for 15 mins and it cut out. tried to drain the bowl, and no fuel came out. . Wait 30 mins and starts back up. Thanks, I'll do the same.

The pinky LOL or the OG Honda 309

🔥

Rzr😅

Hope you mean 150-155 dynojet, if stock jet then its probably closer to a 165 with the lid. Edit: watched end and seen its a china carb.

at least 100k easy

I got them same tires on my tractor sick build

Hell yea brotha

Freaking fire bud

🤡

Link for handlebars?

send it my way dammmmmmmm

🔥

Ai?

Thanks man, my 400ex is doing exactly the same. I'm gonna look into the jetting.

The fix on my end boost controler took it off , lubricated all the holes WD40 .

Pavement princess?

I’m doing the same thing to my rzr 900s front bumper and a arms but with a cheap hand held sandblasting gun

Great video. Question)- If you had about half an inch play in steering handlebar on a atv with EPS while in park and not running, would your first thought be the problem is with the EPS unit itself and needs to be replaced?

Ever notice how Polaris v twins have a deeper growl than a can am v twin

Grow some hair

Nice

That's a big ass tire on twiglike a arms

Hover board is huge in irl damn

RIP balljoint

Nice video but seriously. You run it with that nasty air filter. Step 1 pull the plug get an idea if its rich or lean . Step 2 get rid of that air filter. Install a pro flo system and leave the lid off. Go back to stock jetting plus 1 or 2 rich. The stock needle is the one you had, no adjustment. Then bypass the tps sensor with a bypass plug.

How many times have u rolled?

Blessing 🙏

Maybe just me but did anyone else hear that?? 😳

....Can it be fixed?

👍🏻👍🏻👍🏻👍🏻

Nice truck

What’s the problem

Nice one

I was just wondering as to are you using or leaving in place the old pump and filter and adding this new one outside as you show it? not clear? I assume you are using old? looks hard to get removed and adding extra length fuel line to front? Thank you Lookinh great.