Re-Drilling Axle Stud Pattern At Home (Ford 8.8) To Chevy/HQ
Вставка
- Опубліковано 24 лип 2024
- The HQ has a ford diff in it which was still running the ford 4.5x5 PCD. I ordered a new set of wheels for it which where HQ/Chevy pattern 4.75x5. In this video I make the new wheels fit the car.
- Авто та транспорт
Glad you went for a wide rim instead on mags.....looks great Mate......
first
lovely video.
I was waiting all day for this upload.
Mint Job Joe she dose a solid Burnout too Mate its a good feeling when your hard work pays off. Nice to see the holden 5.0 L getting some use too!!! cheers mate.
Amazing first time I heard imperial measures for pcd. Had to my work my metric internal convertor. Lol. My dad & grandad would work it in a second. 😂. Greetings from Auckland mate.
maddddd just picked up a full wb front for only $650!
Was thinking the same. 😂
A transfer punch needs to be used ie the punch is the same as hole size with pin point therefore the hole is dead centre.
NEVER EVER strike axle flange with hammer ,,,this causes axle flange runout which leads to drum /wheel runout wobble
Either [pull thru] install with air gun with nut and washer OR use a hydraulic press
ALWAYS USE bearing mount/shaft lok [ medium strength ] by Loctite take up the imperfect hole slop
PS there is stud pattern templates although rare in ozzy
I dunno man that sounds a little sus that drilling and centre punch effort, but good luck man hope it works out ok, just be safe.
goes down the road at 100 with not a single vibration.
@@Joedennett69 All good then, cheers mate.
Wouldn't it of been easier to just get FORD wheels?
Wanted all the same stud pattern front to back. Also HQ wheels where half price. Wasn't that hard to redrill them.