how to fix it Fiido d4s new e bike.

the bike came new but it didn't turn on it has a problem the positive (red) wire was not connected to terminal but it was covered in glue and it looks good but when I ex amen it cam out that it not connected, that why i did this video how to check the disconnect the plates and connect directly to battery.
This video is how to check fault if new bike out of box not turning on and solution haw to fix it.

[@martinfitzgerald1]

Brilliant no nonsense fix. A big thank you

[@harryfiona8948]

Turn off the darned music PLEASE!

[@homilie]

Is it possible to charge the battery outside the bike after removing the battery?

[@72fishing]

Yes

[@convictions831]

I didn't think two batteries are in it

[@fun4youck250]

Where is te problem?

[@Buildbeautiful]

He is

[@stephenholmes2816]

What problem you don't say what the problem is

[@Shaundi1-l4e]

his bike did not turn on but i dont recommend doing this. RIP to the bike when it rains and some water get in to the battery compartment

[@kervilou5905]

@@Shaundi1-l4e yes !!!!

[@callumdonaghey1011]

Is there a chance it can explode

[@lombaniwanyachali9775]

Unless if he was trying to troubleshoot the problem, and now he knows the problem was the connectors ,he can replace them.

[@karelp5358]

@@Shaundi1-l4e Hello . My D4s was in the rain too. RIP means bike is totally lost ? I should replace battery? Conector? Controller? SOme help please.

[@callumdonaghey1011]

Can it explode

[@denisdowling]

Can you show controller how to change

[@denisdowling]

Waiting to see controller where is it

[@shockcrest]

It didnt work for me

[@kervilou5905]

??????

[@blemoun]

I think he just made the problem?

[@damijanicki]

I’ve bought this bike recently. I only tried it indoors. My question is when I start pedaling on level 1, after a while el. engine launches and accelerates the bike. However when I stop pedaling the engine keeps accelerating (without using a throttle). In order to quit engine support I have to press the break. Is that normal that after stopping paddling the engine keeps on going?

[@feelgoodmusic3253]

That is not normally

[@othelopescasio3603]

Maybe cruise mode

[@mariogilbrecht6064]

The Controller is the problem. PAS (paddle assist system) the Reaction time is to slow.

[@lombaniwanyachali9775]

Same problem with me, wen I turn on nothing happens until I start paddling then wen I stop paddling ,few seconds it stops, until I start paddling again. I can't enjoy