TRX4M+ Testing @ Cap Sante

Recently finished a new LCG Chassis for a TRX4M+
Basically its a bespoke chassis that fits the WPL C24 Hilux 1/16 body and utilizes 4M underneath. Far better than the WPL platform, and with all the mods and options of a normal 4M.
I went big on everything with this rig to fully embrace the up in scale. It uses my High Clearance LWB plate and 75mm Hightrail Links on both ends for a 191mm wheelbace.
Full Brass axles using MofoRC brass housings and Rampcrab's +11mm axle extensions. Finished off with Injoras 9% OD front/ 16% UD rear diffs, 11KG servo, and some Brass RCAWD wheels wrapped in DJ Crawler 68mm tires.
For the motor I used the new Injora 45T 370 motor w/ aluminum trans/ 24.4:1 gears. Super smooth, craploads of power, and decent wheelspeed. Awesome brushed setup for this 1009g rig.
Ill need a to make a couple last tweaks to the chassis and then do all the prep, (instructions, shipping components, cost/ expenses, etc.) and then it'll be added to the ETSY store.
Thanx for watchin.

[@BeeeZeeeRN]

Damn I'm ready for a few of these! A C54 would be killer!

[@Oppai_Factory]

Thats next. I have one but the chassis needed it similar but too different to retrofit the c24 chassis so ill make a bespoke one.

[@Imfocused247]

Impressive!

[@KTMRider524]

Will the 24.4:1 gears fit in the standard transmission housing?

[@Oppai_Factory]

Ya they should they are smaller than the 40.3:1 gears.

[@russell6869]

Is this the same Chassis on your Esty Store for the wpl?

[@Oppai_Factory]

@@russell6869 it is yes

[@arnoldangel3077]

What model trx4m was it that you can add it on to?

[@Oppai_Factory]

It will work with any since you need the links and shafts regardless, but with the Hightrails, you only need one set where as the Defender/ Bronco need 2 sets of HT rear 75mm links and driveshafts.