Debubbling machines are very expensive if you don't cast that often so it poses the biggest problem for home casting. I use a combination of putting my invested flasks on my fretsaw which vibrates a lot and tap out the bubbles using a stick. It takes about ten minutes for the investment to harden so you have time. The thing to remember is the thicker the investment the more air bubbles, so a looser mix the easier it is to tap out the air bubbles. the down side is a looser mix makes for a more fragile mould so the balance has to be right.. I usually mix up a small amout of investment and paint all my pieces before I build up my sprue tree to avoid bubbles sticking to the waxes, this definately helps..
Debubbling machines are very expensive if you don't cast that often so it poses the biggest problem for home casting. I use a combination of putting my invested flasks on my fretsaw which vibrates a lot and tap out the bubbles using a stick. It takes about ten minutes for the investment to harden so you have time. The thing to remember is the thicker the investment the more air bubbles, so a looser mix the easier it is to tap out the air bubbles. the down side is a looser mix makes for a more fragile mould so the balance has to be right.. I usually mix up a small amout of investment and paint all my pieces before I build up my sprue tree to avoid bubbles sticking to the waxes, this definately helps..
Appreciate the instructions thank you.
Hello, good time, you explain very well, and you also have a very beautiful voice
0:14 ...Can you share the information recorded on the board?. thank you
It’s a chart we prepared for the students at our college. You can use instructions and ratio on your box of investment.
Hello ! Why plaster of Paris can't be use?
It will crack with the high heat of the kiln.
@@julieanctil1440 thanks you for information
Hi, this is Cheick. How could we get this chart?
It’s a chart we prepared for the student at our college. You can use instructions and ratio on your box of investment.
Is there a certain time frame that you have once the mold is dry to pour the casting or will the mold be good to sit a few days if needed?
A few days before putting in the kiln is completely fine.
How do you dispose of the waste investment after casting?
We let it settled and dry and dispose.
need this chart too
It’s a chart we prepared for the students at our college. You can use instructions and ratio on your box of investment.
SELL GOLD AND BUY PLATINUM..///
How do you get a chart
It’s a chart we prepared at the college for the students. You can follow measurement instructions on your box of investment.
It’s a chart we prepared for the student at our college. You can use instructions and ratio on your box of investment.