On the mounting of the turn signal switch I had to cut a portion of the lower shroud in the center of it out on mine to get the halves to go back together. I already had a horn on mine so I installed a micro push button switch in the end of the turn signal lever for my horn button much easier to find when you need it.
I appreciate the way you explained everything perfectly! A lot of videos kind skim over most things and you have to figure it out but not with this video, I have zero questions and know I can go do this now! Thanks!!,
just had to install this kit on a 2024 defender hd10 with doors and hvac system. THANK YOU SO MUCH FOR THIS VIDEO without the video i would have been screwed (the enclosed directions SUCK) ****
2024 defender - switch doesn’t seem to fit inside column plastic cover. The ends of the switch where the screws mount to bracket protrude against the plastic covers (both top and bottom) so to prevent column plastic after reinstall to close snug. There is a plastic wire bracket molded into the switch that needs to be cut off at the bottom and the mounts need to be trimmed for it to fit with ease. I haven’t trimmed yet.
Very good instructions
On the mounting of the turn signal switch I had to cut a portion of the lower shroud in the center of it out on mine to get the halves to go back together. I already had a horn on mine so I installed a micro push button switch in the end of the turn signal lever for my horn button much easier to find when you need it.
I appreciate the way you explained everything perfectly! A lot of videos kind skim over most things and you have to figure it out but not with this video, I have zero questions and know I can go do this now!
Thanks!!,
just had to install this kit on a 2024 defender hd10 with doors and hvac system. THANK YOU SO MUCH FOR THIS VIDEO without the video i would have been screwed (the enclosed directions SUCK) ****
Thanks. Best video I've seen on installing turn signal kit
2024 defender - switch doesn’t seem to fit inside column plastic cover. The ends of the switch where the screws mount to bracket protrude against the plastic covers (both top and bottom) so to prevent column plastic after reinstall to close snug. There is a plastic wire bracket molded into the switch that needs to be cut off at the bottom and the mounts need to be trimmed for it to fit with ease. I haven’t trimmed yet.
Incredibly instructions guys
Where can I purchase this kit
So how does the turn signal switch not move if it's clamped to the steering shaft that moves?
Does it, the shaft is in a housing.
How much does this installation cost?
11:36 11:37 11:38 11:39