Це відео не доступне.
Перепрошуємо.
4x4 Solenoid - 2004-2008 5.4L Ford F-150
Вставка
- Опубліковано 20 сер 2020
- On this episode of Fear No Fix, Chris and Jordan replace the 4x4 Disengage (or Disconnect) Solenoid in a 5.4L Ford F-150 (model years 2004-2008).
DTCs (Diagnostic Trouble Codes) associated with this fix:
• P1832
• P1876
Symptoms associated with this fix:
• Unable to shift out of four wheel drive
Required Tool:
Socket set: amzn.to/3vYpfGm
Screw Driver set: amzn.to/3y4RiWy
If this video helped you out, please like it and subscribe to our channel!
To learn more about BlueDriver automotive tools, visit:
www.bluedriver.com
It's most significant to use the attached shield as it prohibits water from drowning the solenoid, thus fouling up the vacuum pressure. Very important here...
The reason the new solenoid comes mounted to a new bracket is because it is a water shield. It deflects the water coming from the cowl. Water is a leading cause of failure to the solenoid. There is a Ford service bulletin on this repair.
Yes the updated version of the solenoid comes with the rain shield.
Very educational I didn’t know where the thing was located was originally why I looked this up going to try to do it and I’ll leave you a comment how it goes it’s amazing what we can learn off the phone at this point I knew about the water issue read about that a while back I want to see if the issue was the solenoid or hub on my left side keeps locking up on me probably as the hub but the solenoid doesn’t cost that much money so just do both and be done with it at this point looking to replace the truck anyway Thank you for the info
That new part shroud is there for a reason to keep water from dripping on it and failing again
By any chance you think this it’s the problem why my 4high it’s not engaging but the 4x4 is
THANKS
How about a part number for the replacement part??
Wait so this is part of the solenoid a p0750 code I'm getting? Causing the transmission fluid not to flow properly?
Mines you have to put it on Neutral the push foot on brake while turning on and off 4x4 and back on drive and my truck drives fine, rpms drop. But sometimes it sounds like a loud fan noise or 4x4 on.. from 0-30mph then it drives normal from there.. I cleaned the mass flow sensor, and throttle body it made a difference. But still does it. Thinking about spark plugs and change of transmission fluid.. but I think this might be something else..
Is there a place to get replacement airlines ?As mine are severed or broken on the driver side
Will this be the same for a 2004 navigator?
On a 2009 Lariat it is by the radiator on passenger side
My 04 f150 only works in low 4x4, what part do I need ? help
Thanks for the info. My 2006 will engage in 4 wheel drive but will not go into 4 wheel drive. Which solenoid is defective. How to locate and replace this solenoid. Thanks
Will not work in high.
Most likely the 'motor' down on the XFER case. Still you should diagnose it, not just swap parts.
I have 2014 ford expedition 4×4 5.4 I have grinding sound from the driver side and I already replaced the vacuum hoses but sound still and Iam thinking to replace the solenoid. Is that will work 🤔?
Probably already fixed it , but you possibly needed to change the hub due to wear
does it work with range rover sport 2012
Hello!
If you contact support through the app by going to 'more', 'contact us', and 'email' they will be happy to help!
Did not get a code but dash showed 4 Low… found the solenoid whacked it gently a few times- shut engine off- then on- same 4 low- did it again- sit off - wait 30 sec- turn on went back to 2nd!
What about b1892 code?
ummm.. you're supposed to use the new shield/cover
The light on the dash how get off
I have an 04 F150 5.4 3V fx4. Is there anyway I can find where the vaccum hoses for that Solenoid goes too?
it goes to a nipple on the back of the intake.
@@mikeberryman5322 okay thanks @Mike berryman
Dose this affect the Chance of being able to engage into 4wd?
Yes
@dr.mhorse356 I have 2008 f150 when I put it in 4x4 high light never came on. So not sure it engaged or not. When I got home I turned truck off than back on light came on then went off please help have blizzard warning.
@Kenneth Williams
1)Check the fuses passenger kicker panel
2)Might actuater its by firewall under hood passenger side
3) on my truck I put it in 4x4 and it sounds like the wheel bearings ain't catching to spin front tires, I read water/ice disable it. GD LUCK
My f150 only works in low gear 4x4,, what part do I need ? Help
You are supposed to use the new hood. Mechanics lol
P0452
I put 2009 in to 4x4 high and light didn't come on not sure it engaged. When I turn truck off light co.es on and goes off what would it be selinoid
@@kennethwilliams3515 what code is it
@@Nelval573 there is no code
@nelsonvaldez6662 no engine light came on was leaving work went to put it in 4x4 h and no light on the dash for high or low
@@kennethwilliams3515 oh might be your instrument cluster