Ambient Weather WS-2902 & WS-2000 | Performing Maintenance

Поділитися
Вставка
  • Опубліковано 23 гру 2024

КОМЕНТАРІ •

  • @royarchibald6392
    @royarchibald6392 Рік тому

    Weather station display began showing lines for the outside data. Changed batteries in the weather station and the display. Everything worked fine for a few days now it doesn't display outside data at all. Thoughts?

  • @ronkostars4258
    @ronkostars4258 Рік тому +4

    These WS-2902 & WS-2000 are poorly sealed sensor arrays, moisture under their solar collector and the units short life span are common problems.

  • @kevinpavitt4288
    @kevinpavitt4288 3 місяці тому +1

    Might want to go ahead and cut down on saying " go ahead and" by about 90 percent.

  • @honigtrailapiary4341
    @honigtrailapiary4341 2 роки тому

    Does the weather station come with the maintenance kit? Of where can you purchase it?

  • @petecarrolls
    @petecarrolls 11 місяців тому

    my weather display doesnt change should i reset my wind sensor

  • @dannybouska3588
    @dannybouska3588 Рік тому

    Took my WS-2909C solar capacitor over 18 hours to fully discharge.

  • @keithfaulkner1288
    @keithfaulkner1288 Рік тому

    How can I enter the last and long?

  • @ericvanzeyl4483
    @ericvanzeyl4483 10 місяців тому

    This was not helpful. Cleaning it up is good, but I was outside, winds at about 7, and my weather cups not moving. I went out, and turned by hand, felt like gear grinding inside issue. Seems like you would want to clean inside or regrease so that it moves real smooth. Comments welcome on this if you have ever had this issue. I begin to wonder if the wind speeds are accurate.

    • @elcarlstono
      @elcarlstono 3 місяці тому

      Same, I had to put a couple drops of bearing oil down in mine to get it spinning properly again.

  • @thoalex1
    @thoalex1 Рік тому +1

    A 6 minute video to show how to clean the device. #smh