I don’t disagree with you one bit but my current bank account does. 😂😂 Hoping to do a close ratio setup soon soon though. I wish I had $10,000 for a sequential.
@@j_active1111 at this event I was running a stock bottom end original k20z3 with cams and basically full bolt on’s. I blew that motor up because of valve spring failure a few months back and now running a k24a2 with same mods. Suspension is Godspeed Mono RS with swift springs 14k/18k and other misc things.
@@SamWrightRacing nice thanks for getting back that's what I'm in between on my build now should I run the k20z1 or k20a2 for the roller rocker system which I know is a little more heavy duty than other k series valve train and have been looking into the Ferrea rockers as well. How's the k24a2 comparing to previous setups?
@@j_active1111 night and day difference. More power and an assload more torque. Ferrea is supposedly the best stuff out there. Good luck with the build!
Charles-Dylan Mactutus most definitely, the problem is all the turns look the same and this video was only my 6th and final run of 2 days. It’s really hard to memorize the road but I plan to try and study the video and most importantly the corner worker locations to try and remember where I can stay flat out.
Very nice!
A short manual dogbox or sequential is what this car needs.
I don’t disagree with you one bit but my current bank account does. 😂😂 Hoping to do a close ratio setup soon soon though. I wish I had $10,000 for a sequential.
@@SamWrightRacing Yeah,they are damn expensive.
What set up u running ?
As in what? Motor? suspension?
@@SamWrightRacing yes
@@j_active1111 at this event I was running a stock bottom end original k20z3 with cams and basically full bolt on’s. I blew that motor up because of valve spring failure a few months back and now running a k24a2 with same mods. Suspension is Godspeed Mono RS with swift springs 14k/18k and other misc things.
@@SamWrightRacing nice thanks for getting back that's what I'm in between on my build now should I run the k20z1 or k20a2 for the roller rocker system which I know is a little more heavy duty than other k series valve train and have been looking into the Ferrea rockers as well. How's the k24a2 comparing to previous setups?
@@j_active1111 night and day difference. More power and an assload more torque. Ferrea is supposedly the best stuff out there. Good luck with the build!
not badddd but around some of those s curves after the little 1:19 downhill you probably could have held it wide open
Charles-Dylan Mactutus most definitely, the problem is all the turns look the same and this video was only my 6th and final run of 2 days. It’s really hard to memorize the road but I plan to try and study the video and most importantly the corner worker locations to try and remember where I can stay flat out.
Charles-Dylan Mactutus just realized who you are lol. Hopefully next year I’ll be able to remember it better.
Charles-Dylan Mactutus I actually used your video from last year to try and learn it before this year. I will go sub 2 next year.