the adjustment for the slop is at the input. the preload bolt and nut have to be backed off first, the box should be "dry" fluid worked out of it, the large nut at the input splines torqued to 30ft lbs. The preload bolt gets tightened till 4-7 inch pounds to turn the input on the steering box. hold the hex portion and tighten the lock nut. Replace o rings, reattach steering box to frame, install lines, linkage(disconnected pitman from box or centerlink from pitman arm)and steering shaft. If you adjust at the preload only the box will bind up and become nothing short of junk in less than a week.
Make sure that the steering wheel is centered before you remove the steering gear. Before installing the new gear, put them side to side and spin the steering shaft on the new one so that the flat part of the steering shaft is at the same position as the old one's. Don't ask me how I know that's the best way to go!
@@jrbird7571 thanks, i got it right, but put in new pitman and idler arm, new inner/outer tie rods, alignment and still have play in my whell, I cant get it tight
Thank you for your video help me alot 👍
Thank you for sharing
not what that adjustment is for, that adjustment is for preload on the gears it does not make up for wear slop.
the adjustment for the slop is at the input. the preload bolt and nut have to be backed off first, the box should be "dry" fluid worked out of it, the large nut at the input splines torqued to 30ft lbs. The preload bolt gets tightened till 4-7 inch pounds to turn the input on the steering box. hold the hex portion and tighten the lock nut. Replace o rings, reattach steering box to frame, install lines, linkage(disconnected pitman from box or centerlink from pitman arm)and steering shaft. If you adjust at the preload only the box will bind up and become nothing short of junk in less than a week.
how do you make sure the new box is centered?
Make sure that the steering wheel is centered before you remove the steering gear. Before installing the new gear, put them side to side and spin the steering shaft on the new one so that the flat part of the steering shaft is at the same position as the old one's. Don't ask me how I know that's the best way to go!
@@jrbird7571 thanks, i got it right, but put in new pitman and idler arm, new inner/outer tie rods, alignment and still have play in my whell, I cant get it tight
@@rickoddo9811 Check the rag joint. I've heard folks complain of a faulty steering sensor.
@@jrbird7571 thats new too
Thanks for the video