Mercedes Benz W201 W124 rear wheel bearing, brake shield replacement
Вставка
- Опубліковано 11 жов 2024
- I hope you enjoyed this video. Please use due diligence - work at your own risk.
No fit guarantee given - but here are the "exotic" part numbers I used (201.122, '91):
Brake shield/backing plate left side: 2024201444
Brake shield/backing plate right side: 2024201544
Seal (1x/brake shield): 2014230080
Screws (3x/brake shield): N914125006501
And to push back the hub, what you use for. Thank you very much for the information. I am a little frustrated with the hub in US. You don’t find tools like yours.
No problem. Are you about to install the hub into the new bearing?
Please let me know We could find hub puller tool please
Toppie
Where can you find the 3 Bolt hub puller?
Hi, sure, the bearing toolset is BGS 67301. Looks like it has been updated since I got it back in 2018. I got it on eBay, I see it on Amazon as well.
Почему не использовать обратный молоток , зачем снимать колодки ручного тормоза?
I hope Google translate didn't butcher the text, but here we go:
The BGS 67301 tool has the 3 bolts - which I really like, instead of a slide hammer for extracting the hub.
The parking brake pads had to be removed to get to the brake heat shield / anchor plate, which had rust holes and not very fit for fight in the long run.
@@christianwc9458 у меня есть как обратный молоток ,так и спец сьемник для сьема ступиц в форме подковы , сделан на фрезерном станке, болты для сьема ступиц я вижу впервые , у нас нет таких сьемников , они ведь нагружают резьбу на ступице.
И еще , сегментный сьемник хоть и снимает внутреннее кольцо со ступицы , но для таких вещей есть спец сьемник типа цангового типа, у вас в продаже разве нет таких?
И еще , сколько пробег на вашем Мерседес w201?
Hubiera puesto el rúleman primero y después la lata.
Hi thanks for commenting. Not quite sure what you mean, in any case: I chose to wrench on the smaller extractor tool nut, instead of the big 38mm bolt with the thrust bearing. To be honest I can't quite recall the reason for not positioning the 38mm bolt outwards, I think it was lack of space.
Please let me know We could find hub puller tool please
Some people like to use a sliding hammer, I just chose the 3 bolts. Being careful and pushing out the hub evenly to not stress the threads. As mentioned before, I used BGS 67301. Have a good day.
@@christianwc9458 с какой стороны устанавливается радиально упорный подшипник на сьемник с той стороны и нужно вращать , а так , какой толк от него?