Power cord replacement on Hoover WindTunnel model U5720 vacuum

[@jmango4665]

This procedure was spot on. I followed along step by step and replaced the chord without any issues. Thanks for sharing Larry

[@midlat24]

Thank you for posting this detailed video. It made my cord replacement activity go a lot smoother. I appreciate the amount of detail that you included in the video instructions.

[@matt636r]

Thank you. After watching this video, replacing the cord on our vacuum was a snap.

[@stevenmartin4054]

Thank you sir. I had a different model Hoover but the principle was the same.

[@JefferyADavis62]

Thanks so much! Very informative. For future videos, maybe don’t shoot in landscape mode so it’s easier to view.

[@吳佑佑-x8l]

better than expected.

[@margaretolis2393]

Thank you so much!!

[@randycummins123]

Thanks For Vid. Buddy....Allowed me to replace defective switch....

[@chowman007]

Hi, is there a video on how to remove the motor of a hoover UH72511 model? Am having a hard time. Please advice. Thanks.

[@larryzuckett2598]

If you are using Buchanan wire nuts, the recommendation for 1 #16 awg wire connected to another #16 awg wire is to use the small WT51 yellow wire nut. Check the table on the side of the packaging on the wire nuts.

[@gregknauss6686]

This bros from Pittsburgh for sure hahaha

[@paulsypersma7165]

This guy woll make you go to prison,dill into the bulkhead and get them,plug and go.Hell with tape,your own kinks.

[@tylonbarnes9678]

I did the same the WindTunnel self propelled u6432 900 and u6476 900

[@larryzuckett2598]

Hello all, this is my first production. I am trying to figure out why I have the bands on the video. The format is 16 x 9 HD using Cyberlink Power Producer. Any suggestions would be welcomed.

[@RalphTavarez]

What if my switch has a yellow cord