All in [1] Power Supply with irfz44n Mosfet - Adjustable Voltage Regulator

All in [1] Power Supply with irfz44n Mosfet - Adjustable Voltage Regulator
in this video, i made adjustable power supply using irfz44n mosfet,which works great, you can make it at home,simple tools for every home..
CIRCUIT DAIGRAM..
drive.google.c...
0-35v adjustable voltage regulator using single Mosfet
#tools #brilliant #simple #diy #creative #smartgadgets #electproject #electronics #experiment #tipsandtricks
#device #super
all my videos playlist.
• All videos will make y...
must watch!!
this device should be in every home\\brilliant idea
• Brilliant idea!! THIS ...
• Brilliant idea!! THIS ...
Simple tools should be in every home | Brilliant idea
• Simple tools should be...
• Simple tools should be...
this device should be in every home | brilliant idea
• Simple High watt inver...
• Simple High watt inver...
0v to 30v regulator circuit
adjustable power supply 10ampere
science & technology
simple tools for every home
this device is very helpful, you can make at home
Thanks for watching..

[@creativetech3680]

Good job

[@techprojects9495]

Good. project for every home

[@electronicogg7174]

Like Uzbekistan 👍

[@ayashasod377]

😘😘

[@RajendraSamant-d7o]

Thanks for the reply you have suggested to me. One more thing I wish to ask you what is supply voltage fed to operate voltmeter after 150 ohm resistor. In my case after making circuit and using 12-0-12 V transformer output voltage after rectification is 36v.

[@electproject]

In volt meter already 5v regulator installed, and secone ans is that u used resistor for as saftey of volt meter you use also 180 ohm resistor

[@claudiotomassi4448]

Quando finisce la carica delle batterie si può mettere un led?

[@yogendraps96]

Please mention all components and power plz

[@RajendraSamant-d7o]

Will 47k potentiometer do instead of 10k

[@electproject]

Yes bro

[@joaomachas3255]

please let me know where 0.33 resistor is applied, because the final diagram shows 180 ohms

[@electproject]

0 .33 applied in source pin

[@AdamTheBot]

Maximum Input ?

[@rajanm5824]

Please provide the circuit diagram.

[@electproject]

Circuit daigram in description below!!

[@leopoldofernandezjr.508]

Nice but the amp is very low..

[@AdityaSingh-jg3je]

It's only for charging

[@electproject]

IF I USE INPUT HIGH AMPERE SUPPLY SO OUTPUT WILL BE HIGH AMPERE..YOU CAN USE HIGH AMPERE POWER SUPPLY WITH THIS PROJECT
THANKS FOR WATCHING..

[@harblasvirdi9096]

why the voltage drop when use 12 v motor

[@lomgshorts3]

Crappiest way to solder I've ever seen. "A good mechanical connection is necessary" before solder is applied to the joint.