Thank you so much for this video I just bought a sweet sixteen with the insight table and whilst the machine is different your instructions were very clear on setting up the table
I just got my capri Yay! But I must be installing the knobs on the table insert wrong, because they will not tighten enough to hold the insert in place
We found that when it was time to install the table insert and the flywheel of the machine had to line up with the back of the table that the machine base was poking out the end. If you installed the machine base with the flanges up then the machine would not sit level on the base.
@@letitiamoore6315 Thanks for the explanation. I just checked and the instructions specifically mention that the flanges should be facing down during installation, which means that they would face up when the table is flipped upright, it also shows this in the picture on the front of the instructions. This is how I have installed it and you are correct, the back of the machine is raised by the flange. Why do you think they ask for it to be installed with the flanges facing up? I think I will cry if I have to pull it apart and start again!
Thank you so much for this video I just bought a sweet sixteen with the insight table and whilst the machine is different your instructions were very clear on setting up the table
I just got my capri Yay! But I must be installing the knobs on the table insert wrong, because they will not tighten enough to hold the insert in place
Hi Kay ensure that the locating arms are closest to the underneath of the table insert.
Did you put the machine stand plate in upside down?
We found that when it was time to install the table insert and the flywheel of the machine had to line up with the back of the table that the machine base was poking out the end. If you installed the machine base with the flanges up then the machine would not sit level on the base.
@@letitiamoore6315 Thanks for the explanation. I just checked and the instructions specifically mention that the flanges should be facing down during installation, which means that they would face up when the table is flipped upright, it also shows this in the picture on the front of the instructions. This is how I have installed it and you are correct, the back of the machine is raised by the flange. Why do you think they ask for it to be installed with the flanges facing up? I think I will cry if I have to pull it apart and start again!