Disassembly of flsun-V400 extruder, for reference only
Вставка
- Опубліковано 16 вер 2024
- Locations that may cause plugging
1. Gear set: confirm that there is no waste residue filament in the extruder gear set,
2. Nozzle: withdraw the filament, heat the nozzle to 240 °, and use the attached 0.3mm metal needle to pass through the nozzle to ensure normal passage without resistance.
3. Metal throat: remove the hot end and observe that there is no residual filament in the throat, otherwise use tools to remove the residual filament or replace the metal throat
After confirming the above positions, operate and load the filament. First, confirm that the filament is straight and free of winding, deformation, bulge and inclination. Confirm that the filament passes through the driving wheel and idler wheel group of the extruder. Introduce the lower guide pipe and enter the hot end through the throat. When a perfect filament is extruded from the nozzle.
Thanks, those two screws that are millimetrically small and hidden in the front are what almost made me quit thinkering with it.
Let's hope I can finally print without thermal run-outs
Bro … Perfect timing. Had filament break off just after the gears, need to break it all down!
Hi. I need change stock gear to hard steel. What gear type i need buy for replace ?
Estaeia bueno que hablen o pongan carteles explicando
Hey hi, do you know why my V400 Its no working anymore? It was connected to outlet, Yesterday worked like always but today no, I think it was a discharge of energy, could you help me?
Bro can you do one tightening the belts please