Ok just got all working with blink functions, take your ground off wire like original. Your inside blinkers are tied into all this so you will need canbus led no polarity in all four corners. I used las fit off amazon. Also used 1157 switch backs in front with built in resistors they don't get to hot. Use two electronic flashers with ground on both. I now have leds on entire vehicle.
Ok just got all working with blink functions, take your ground off wire like original. Your inside blinkers are tied into all this so you will need canbus led no polarity in all four corners. I used las fit off amazon. Also used 1157 switch backs in front with built in resistors they don't get to hot. Use two electronic flashers with ground on both. I now have leds on entire vehicle.
Chad have link for the items u used??
Should I ground the ground coming from the side blinker individually??
I wouldn’t do it, I almost did but figured out the way to do it and still have the cross flash which is factory.
My font switch backs will blink but not illuminate the running lights with certain leds in the marker spot. I will give your trick a go
Gonna do this today when I get home. I have these ohm resistors installed and they work but this is cleaner
@@1tonystunts I didn't even know an resistor was an option. But if this is better than I'm glad I didn't waste my time
Are they still working good? I'm doing a Monte and mine are unhappy also.
@@ChadFlanagan-fw1eh yeah, haven't had any problems since making the switch
Use the same lamps inside dash.