DIY motorized thermal glider

I built my first motorized thermal glider from scratch. It was inspired by Andrew Newton's motor gliders. So I decided to build one. It is very easy to build and you can improve and replace the parts if you want. The wingspan is 2m and the AUW is about 500g.
ESC: Firmware Electronic Speed Controller Esc 40A ( I think it is more than enough for this setup.)
Motor: 9imod D2830 1300KV 3.175mm Brushless Outrunner Motor 2-4S
Prop: 1 Set HY New Plastic Electric Model Glider Flying Folding Propeller (7x3)
Servos: JX 2.6kg Mini Servo 1/2/4PCS PDI-HV0903MG DC6~7.4 V Digital Metal Gear (2 pieces)
RX: FrSky V8R4-II 2.4Ghz 4CH Receiver
Sweet Dreams by BatchBug | / batchbug
Music promoted by www.chosic.com...
Creative Commons Attribution 3.0 Unported License
creativecommon...

[@amonus-air2160]

very cool! I like the way you did your fuse. Looks light and strong.
Look forward to the maiden. 😎👍

[@goldenfish77]

Thank you for your words. The wings a little bit weak, but I try to reinforcement it. I will test it soon.

[@collinmccallum]

very cool!

[@goldenfish77]

Thank you!

[@ifeket663]

Szép munka! Mikor látjuk a berepülést?

[@goldenfish77]

Köszönöm szépen! Nemsokára, csak most elég ramaty az idő. A széljárás nem kedvező...

[@coverdestroyer3572]

Man do you know how to get ribb of apogee plan? I don't know how to get the ribs plan

[@goldenfish77]

Sorry, I do not know. I like and know that 2ch glider, but that is all.

[@stevengreenhough4232]

Google "Airfoil Tools", then select Ag03 airfoil in the chord(s) you want...