Personally I would’ve enjoyed a little intro and outro and maybe a cta (call to action) to like and subscribe maybe, I will agree with you that the middle part of the video was very on point as information goes but, a little pizaz never hurt anyone
Did it and it went just fine. Just got to be careful removing the steel spark plugs from the aluminum head, be careful not to strip anything. Keep compressed air handy to blow debris out from around the spark plug, its down in a hole.
My jeep is missfiring BAD. New plugs about 3 months ago. Starting to have bad cold start barely starts. When running its ok. But shut off start back it runs like TOTAL crap. Misses badly.
Thank you for the post. Was the extension you used to remove/install the plugs against the firewall the same as used on the other plugs or a special reach extension?
Well done video, no nonsense, step by step, points out exactly which tools you need (T30 torx, #8, #10, etc) and the video is clear. Thank you!
This is a great video. Jumps straight to key points. Instant subscribe
Nice video. Right to the point with no Bull S**t. Good job.
Personally I would’ve enjoyed a little intro and outro and maybe a cta (call to action) to like and subscribe maybe, I will agree with you that the middle part of the video was very on point as information goes but, a little pizaz never hurt anyone
Great video, straight to the point. I just want to know how did you get disconnect the spark plug closest to the cabin
Well, I've avoided doing this for years because I thought it was going to be a major ordeal. This looks simple, thank you.
Did it and it went just fine. Just got to be careful removing the steel spark plugs from the aluminum head, be careful not to strip anything. Keep compressed air handy to blow debris out from around the spark plug, its down in a hole.
Nice looks like you don’t have to swap the spark plug wires?
Damn useful video thanks never delete it 🙏🏻😒👍🏼
super helpful! thank you!
hi on this jeep if you are replacing ignition coil too does it need to be purchase at dealer ???? or can it be bought at a local car parts store??
Great video brother
Is ngk better than champion for an 06 jeep commander?
How much torque do you use?
Or what do you recommend for tightening the spark plugs? Thanks in advance
My jeep is missfiring BAD. New plugs about 3 months ago. Starting to have bad cold start barely starts. When running its ok. But shut off start back it runs like TOTAL crap. Misses badly.
Great job.
What jeep is this🤔
Commander
Do I disconnect the battery
You should always disconnect the battery when working on your car. I usually just pull the negative side off the terminal and tuck it out of the way.
what did you gap them at ?
ENGINE / PLUG TYPE / ELECTRODE GAP
3.7L ZFR6F - 11G (NGK) 1.1mm (0.042 in.)
4.7L RC12MCC4 1.01 mm (.040 in.)
5.7L Champion - RE14MCC4 1.14 mm (.045 in.)
@@Massfeller thanks
are they pre gapped?
Thank you for the post. Was the extension you used to remove/install the plugs against the firewall the same as used on the other plugs or a special reach extension?