Newer valves are made in a way that it's hard to remove with out demaging valve. But you can still fill it, the trick is to introduce the co2 slowly as a build in valve acts on rapid pressure changes. Just turn go slow and you'll be able to recharge it with out any modification.
@@sanaaamar5979 open the tank that you're using to fill very slowly till you start to hear the liquid flowing and with some practice you'll be able to do it if it doesn't work at first time try again and open valve slower till go get the it.
the dual anti refill valves are a bit trickier to modify but there are two good videos on youtube that outline a couple ways to achieve the results you want ie "quick fills"
Is there a ball bearing or something inside the safety valve, i took mine all the way off an now when i tried filling it everything leaks out the safety valve
I am so confused? Came here to find out how to refill my tanks easier….what is the goal of this? Rethread and drill out 1/2”? Why? For what? How would that at all work again normally?
Newer valves are made in a way that it's hard to remove with out demaging valve. But you can still fill it, the trick is to introduce the co2 slowly as a build in valve acts on rapid pressure changes. Just turn go slow and you'll be able to recharge it with out any modification.
For Better World this video was for use in air guns
How slow? Do you have to turn the black valve into the cylinder all the way or just a little bit?
@@sanaaamar5979 open the tank that you're using to fill very slowly till you start to hear the liquid flowing and with some practice you'll be able to do it if it doesn't work at first time try again and open valve slower till go get the it.
the dual anti refill valves are a bit trickier to modify but there are two good videos on youtube that outline a couple ways to achieve the results you want ie "quick fills"
How much psi do you need for the air gun?
Good valve pcp homemade
What valve type does the cylinder use
Is there a ball bearing or something inside the safety valve, i took mine all the way off an now when i tried filling it everything leaks out the safety valve
No it's a burst disk. You either punctured it, or it's leaking from the threads, and not the valve
Ok, Thank you
@@ARC3333 sure thing. I'd suggest wrapping the threads on ptfe tape and trying it again.
No its burst
you could plug it, depends on how risky you want to be / what psi you;re filling to
Hi. Do you know what is the size of co2 pin valve o ring ?
renif333r the large one seen at the beginning of the video? The one that seals the entire brass piece into the sodastream bottle?
That little one on the pin.
renif333r well there's a white nylon? washer. And the two black nitrile o rings. I'm around now. But I can check later
I would be grateful
@@renif333r Did you ever find the inner pin seal? I need a replacement one.
Does anybody know where to buy o ring for the pin valve that goes between the soda stream bottles?
Good luck
@@swandonovan iiiui
@@swandonovan iiyou
Since you know the valve: can I easily get CO2 out of the bottle? I frankly only need CO2 quickly.
where can you purchase these valves?
Tori Ward they come in sodastream bottles
do you have any ideas where I could purchase new ones? Mine broke :(
Tori Ward new? No. Can find complete used bottles on ebay
eBay have them listed.
I am so confused? Came here to find out how to refill my tanks easier….what is the goal of this? Rethread and drill out 1/2”? Why? For what? How would that at all work again normally?
You found the wrong video