Installing a Bottoms Up tap handle display

Since the Bottoms Up draft beer system doesn't dispense using tap handles (like a faucet system), you'll need to display your draft selection. We provide a stainless steel display with every install, but if your counter or bar is stone, concrete or any other material that's difficult to cut/drill into, you'll need to prepare the area ahead of time.
Here are some simple ways to measure out the holes needed to install the tap display.
The spacing of the holes will vary, but your installer will provide the measurements in the pre-install communications.
For more information, give us a call at [phone].
0:23 How the display is secured
1:03 Space needed under the bar
1:46 Where to ideally put the tap display in relation to the dispenser (1/2" away from far edge)
3:25 Measuring with no dispenser in place, in-counter dispenser (3/4" from hole)
5:27 Measuring with no dispenser in place, countertop dispenser (3/4" from hole)
6:21 Subtracting dispenser length from display hole centers and divide by two, for equal spacing
8:15 Measuring from the sides of the dispenser
9:02 Marking the drill holes
9:58 Double-checking your work
10:20 Measuring the holes if you already have the tap display, by tracing the feet (center of hole is 7/8" in from foot edge)
11:38 Drilling and routing the holes
12:30 Checking the holes are straight
12:39 Attaching the bolts to the tap display
13:32 Tightening the bolts
14:34 Checking the measurements
15:90 Final notes