Fixing My Sway Bar Because I Screwed Up - Ram 2500 Thuren Active Rate Suspension Overland Offroad

well I doubt this was the cause of my issue, but it was definitely wrong.
Thuren Active Rate Sway Bar
www.thurenfabrication.com/col...
Strange Issue With Ram • Strange Issue With The...
Front End Problems • Ram 2500 Front End Pro...
35" Tires Are a Rip Off • 35" Tires Are A Ripoff...
Ram 2500 Series
Snap Outfitters Full Walkthrough • I Bought A Pop Top Cam...
Why I got the Hemi? • Why I Got The Hemi 6.4...
Snap Outfitters Treehouse Walk around! • I Bought A Pop Top Cam...
Installing Everything! • 2021 Ram 2500 - Instal...
Riversmith River Quiver Rod Rack • My Full Time Fishing V...
Slide Out Kitchen • I Built A Hidden Slide...
Camper Bed Build Intro • Intro To The Ram 2500 ...
Camper Bed Build Part 1 • Ram 2500 Camper Bed Bu...
Fridge Slide Camper Bed Build Part 2 • Low Profile Custom Fri...
Camper Bed Build Part 3 • Hidden Storage In My C...
Intro To The 12 Volt System • Intro To My Ram 2500 1...
Temporary 12 Volt System • My Temporary 12 Volt I...
Full Walk Around • Ram 2500 Build Full Wa...
Bolting Down My Camper Cap • Bolting Down My Snap O...
Westin HDX Pro Rear Bumper Install • 2021 Ram 2500 - Westin...
Bushwacker Fender Flares • Ram 2500 Fender Flares...
Sanding and Painting Steel Bumpers • 2021 Ram 2500 - I Pain...
Wiring Light Bar to Upfitter Control Module • Ram 2500 - Wiring Ligh...
Color Changing my Light Bar • Color Changing my Ligh...
20" Light Bar Install • Westin HDX Light Bar I...
12,000 LB Winch on a Budget • 12,000 LB Winch on a B...
Reverse Light Upgrade • Ram 2500 Upgrade is a ...
AvalonKing Ceramic Coating • AvalonKing Ceramic Coa...
Forklift Hit My Ram 2500 • A Forklift Hit My Ram ...
How I Got My 2500 to Ride Like a 1500 • How I Got My 2500 To R...
All The Gear I Need To Install • All The Gear For My Ra...
Snow Chief Group • Snow Chief Group is a ...

[@loveracing1988]

The only thing any kind of leveling kit would change is castor, which isn't a tire wearing angle. If you didn't have it aligned to thuren specs get it redone anyway, you want zero toe.

[@GiantsNinerFan56]

Hopefully you did the alignment with your payload on the truck. The other edge wear in the front could be from excessive camber from all the weight.

[@loveracing1988]

Excessive weight would cause negative camber not positive. Also there is no camber adjustment with a solid axle without adjustable ball joints.

[@jamesmorris-tj9vd]

So if my truck is bouncing a little too much you think I need to add more freeze to my zerks?

[@NickMango]

I would first check your tire pressure. If it’s too high, you’ll be all over the place. But if you have a greaseable sway like mine, then I’d check that too. Last thing to check would be shocks. See if any are leaking. Bad shocks will cause it to bounce too.

[@alg6741]

What I meant is that visually and by the numbers on your mic they are different in length..... so it makes sense why you had to grind one so it would work......I just hope that grinding that little bit did not somehow damage the grease fitting.
I was worked as a mechanic years ago so I have dealt with those grease zerks quite a bit.......also since you live in a place where it snows consider using anti seize everywhere that it is safe to use.......I have a 2014 Ram 2500 4x4 diesel
I am planning on adding bumpers and a leveling kit kinda more or less what you have done to your truck.....I'm in Florida and use Rotella T6 in 15w40 but I highly recommend the same oil but maybe in 5w 40 for you......take care

[@YOUARESOFT.]

swaybars are junk. just throw it away. never used one on ANY of my many rams

[@maxpain7197]

That's ridiculous. You obviously never towed anything with your ram, or drive in canyons at 75.