Thank you, yes much better haha. It was a combination of a few issues.. i did add some more noseweight, but i think it would have flown without it. I think it was also the fact it took off far too soon, should of held down in to keep it on the ground, but it bumped into the air early first time and didn’t have enough speed, so was stalling
Thank you 🙌🏻 They were both brand new engines so fairly matched from the start. Then tweaking the needles and running them in to get them matched best as could. Any final adjustments done with throttle trim and curves in tx settings
Beautiful! Congratulations on a successful maiden! That takeoff was absolutely gorgeous.
Thank you! 🙌🏻 I was pretty happy with it too
So nice to see three bladed props!
Great job Aaron, well done indeed 👏
Congratulations she looks great ✈️
Congratulations!! It's beautiful
Fantastic to see, very well done!
Well done 👏👏 brilliant !!
good things take time....nice work!
There we go ! Nice job
Awesome landing for what is actually the first time. Brilliantly done.
Attempt #2, hardly a maiden.
absolutely Brilliant, well done
Thank you 🙌🏻
Yes, very nice scale like take off and landing...much better than the 1st attempt. Was it mainly a CG issue?
Thank you, yes much better haha. It was a combination of a few issues.. i did add some more noseweight, but i think it would have flown without it. I think it was also the fact it took off far too soon, should of held down in to keep it on the ground, but it bumped into the air early first time and didn’t have enough speed, so was stalling
We have one at our club that's been flying nearly 30 years. Nice job!
Now you need to launch out little paratroopers.
That may take some work 😂
Does it have retracts?
Where did you end moving the CG to? Also, mind sharing your control throws?
Thanks
Spectacular! How did you get the engine speeds balanced?
Thank you 🙌🏻 They were both brand new engines so fairly matched from the start. Then tweaking the needles and running them in to get them matched best as could. Any final adjustments done with throttle trim and curves in tx settings
Excellent ! Since you reduced the size, what retracts di you put in ? Thanks
It’s actually only fixed gear on this one. As the fuel tanks, throttle servo etc have been put in the areas where the retracts would go
Tolles Modell😘
Not bad! 😁
Tough crowd mate! 😂
what wasthe final weight?
I can’t remember at the moment, but around 16kg
Having the CG correct makes all the difference in the world, doesn’t it?
Flies and sounds great. Good choice not going electric.
Thanks! 🙌🏻 Was always going to be petrol for me 😉
Greetings from Mexico.
Hi from the UK! Thanks for watching 😊
*Let the Sunshine In...*
Uhhh, the tail *didnt* lift during the taxi test LOL .