Building a Nitrous 540 BBC Engine (1,000 Horsepower)
Вставка
- Опубліковано 30 вер 2024
- HOW TO VIDEO LINKS:
How to Gap Piston Rings - • How to Gap Piston Ring...
How to Check PTV Clearance - • How to Check PTV Clear...
How to Measure Bearing Clearance - • Measuring Bearing Clea...
How to Measure Pushrod Length - • How to Measure LS Engi...
--------------------------------------------
WHERE I WORK:
www.smedingper...
@smedingperformance
--------------------------------------------
MOTOVLOG EQUIPMENT:
GoPro: amzn.to/3HUKn7U
Media Mod: amzn.to/3xhxJLk
Mic: amzn.to/3E44Fe7
Volume Control: amzn.to/3DWqnRe
--------------------------------------------
GENERAL FILMING EQUIPMENT:
Camera: amzn.to/3Ymtw4V
Accessory Kit: amzn.to/3DZRY43
Wireless Mic: amzn.to/3IgM0hA
Lavalier Mic: amzn.to/3HUN4Gy
Micro SD Card: amzn.to/3JZTLd6
--------------------------------------------
DISCLAIMERS:
All videos are filmed in Mexico with trained professionals, unless stated otherwise.
All content posted under this domain has no affiliation with its poster and any relation to the rider portrayed in any way which it includes. The rider is not limited to his or her likeness, location, or personal identity.
Country music background was on point 😎
10-71 blower hanging out the hood
I understand their limitations but it’s all about the look and sound
FinalLy saw the cam installed first, never saw it done this way in any online builds, been doing it that way for years.
Why not a kickout pan for that 4.25 stroke?
F2 procharger would be my go to.
I'm shocked they aren't using T&D shaft rockers Or the Jesel brand ..
Thank god, we never get to see people building big blocks. Everyone only builds smallblocks and LS on vids.
Neither, real engines are n.a.
YESSSS
This is better than watching a movie on tv
Few issues. One, why aren't you checking rod bolt stretch? Why are you using silicone on a rubber gasket??? Why did you use silicone on the outside of the rear main??
It will change every time rod bolts are torqued. the only proper way to tighten them is by stretch. But admittedly, people have only been torquing them for decades without issue on most stuff....@@bigboreracing356
How often do you have your torque wrenches recalibrated?
HOW MUCH $$ for this motor
"Always lube your tips" -Smeding Performance. 🤣
New merch dropping soon...
Thumbs Up! Are your cylinder heads designed, cast, and machined in the USA. Who actually makes these heads? Thanks!
Nitrous for vlean, simple and underhood. ??? Why do you lay the torque wrench on the pan rail when setting?
How much is this combo ?
Nitrous is way cheaper than a blower setup and makes just as much power.... good choice
think about video explaning slections of oil pumps ... im really intreasted to know more .. great content as usual
Blower for sure power is allways there and I think its much better for engine
Neither.
First 👍 's up EG thank you for sharing
He adjust valves the same way as I do
Cost?
I think the music has more of a Southern Yacht Rock sound to it , But I'm deaf from holding my ear up to exhaust pipes my whole life
Personally I would rather have a blower. They don't need bottles refilled, and usually will have a wider, more controllable, and consistent power band. Not to mention gobs of bottom end torque that gives more smile per gallon...