How To Fix a Featherlite Weedeater by Cleaning the Carburetor

Поділитися
Вставка
  • Опубліковано 20 жов 2024
  • Fix a Troy Built Weedeater: • Fix a Troy Built 4-Cyc...
    HOW TO Fix Lawn Mowers Playlist: bit.ly/2oYau9g
    Quickly covers the minimal parts replacement and tools required for general repair. Completely clean and with compressed air and blow through all internal passages for best results. (Although not performed in this video) Remove the needle and clear the jet it's sitting in. Always replace the metering diaphragm. When rebuilding the carburetor it is best to use hand tools to accurately judge how tight the screws are being placed. Power tools were used here for speed of reference. The part used here is a 95-526 Walbro metering diaphragm.
    Amazon Weedeater Featherlite Carburetor Kit: amzn.to/2YjXlEX

КОМЕНТАРІ • 18

  • @crazyamericangamer7036
    @crazyamericangamer7036 5 років тому +4

    Good video, i need carb work done on both my early 2000s era weed eater an lawn mower but u can buy a new carb for the lawn mower for 13$ so ill go that route

  • @AntonioGarcia-ln6nm
    @AntonioGarcia-ln6nm 2 місяці тому

    Question how to fix my weedeater do not start

  • @moname7017
    @moname7017 5 років тому +2

    Thank you!!

  • @selkywaters
    @selkywaters 5 років тому +2

    What about gaskets under and on top of the carb? Do you need them both places or just one?

    • @AdamPenningtonadamcpennington
      @AdamPenningtonadamcpennington  5 років тому

      If it's the metering diaphragm on top of the gasket. Pump/ primer side diaphragm goes against the face of the carb (or on bottom of the gasket).

  • @martystevens3969
    @martystevens3969 7 років тому +2

    Amazon has a Stens catalog with their complete line of parts. They have diaphragms in bulk. It is diaphragm only. Look on the carb. for Walbro or Zama. Check the number in it. A weed eater carb. is looked up by Make of the weedeater like Featherlite FL 20. Don't replace the needle valve. The spring is tricky. Make sure the intake gasket is there. Set lo mixture for highest RPM'S at idle and hi mixture for highest RPM'S at full throttle.

  • @riod43
    @riod43 2 роки тому

    What model is this?

  • @jeil5676
    @jeil5676 3 роки тому +1

    It would have been cool to see if it actually started and your fix worked.

  • @hankbridges5055
    @hankbridges5055 5 років тому

    If the primer don't prime, check the fuel line in the tank to see if it broke off in the tank. Drain the tank and look.

  • @bhoward9004
    @bhoward9004 8 років тому

    Great video!!!

  • @dCash117
    @dCash117 Рік тому

    I got one for free and I think the only thing wrong is that the pickup tube broke off inside the tank

  • @vintagemxer9165
    @vintagemxer9165 2 роки тому +2

    Hahaha - but did it run? That was a waste of my time

  • @stewartj2677
    @stewartj2677 10 років тому

    Hey,
    This is Jonathan from PES. Please give me a call.
    Thanks

  • @tomsherry8961
    @tomsherry8961 3 місяці тому

    Why do these guys love to say , go ahead. Let's go ahead and. Blah blah blah. I went ahead and.. can't you just say what you are doing without "go ahead " before it.