Changing Filters and Fluids in My Bobcat 873 (Fixed Version)
Вставка
- Опубліковано 1 лис 2022
- Changing the filters and fluids in the old 873! I had problems with the last upload. This version should be good to go. Sorry for any inconvenience!
- Авто та транспорт
Shave the plastic rings at the end of the plastic portion of the dipstick. They will break and wrench havoc
I had that happen on an old audi I had lol it was a real pain in the ass
taking off the oil fill cap makes the oil drain 10x faster
Typically I just loosen it so it will pull air through. I always worry about something falling in the fill while I'm messing around so I try not to leave it completely off.
I just got one too what type of hydraulic fluid are you using.
The thing is a tank. I've been running traveler iso 46 and it's been good to em so far.
Thank you
My 873 goes forward and back but no lift or tilt after rebuilding two cylinders. Any ideas???
I would say that has to do with the safety switches. There should be a box that will light up next to each safety before it will allow you to lift the arms. Make sure they're all lit. It seems lile if I dont slam the safety bar down it wont unlock the lift safety so make sure you check all the switches.
@@hollowaysgarage9332 Thanks for your response. Will definitely check out.
@@cryptopops6891 good luck buddy
Do you mind sharing the fluid specs on your 873 I just bought one and can’t get info online
@@unidozkc I just ran ISO 46 from tractor supply. The manual specs it with 30 weight oil if I remember correctly so I think newer ISO46 would work better.
Where did you buy your parts from?
I believe it was skidsteersupply.com