Hyundai I30 How To Remove Rear Bumper Removal Replacement Removing
Вставка
- Опубліковано 8 лют 2025
- Hyundai I30 How To Remove Rear Bumper Removal Replacement Removing
This Channel is made as a reminder when making minor repairs or providing information about vehicles.
I’m here to just guide you if you know what you’re doing.
Don’t make repairs that you’re not sure you know what you’re doing !!!
For more detailed information, if something is not clear to you ,or you don't understand something, contact your local dealer or service for that vehicle
Any repair on the car you do at your own risk !!
PLEASE SUBSCRIBE and SUPPORT my UA-cam Channel :
/ @tehnicalife - Авто та транспорт
Thank you very much the video helped a lot
Hi great job..but looks like a big job.
I’ve got a question my rear parking sensors are not working.
Is it possible to take the back covers off underneath just as you did,rather than the full bumper in order to get to the sensors & to see what’s going on.
Thanks.
when the sensors are active (reverse gear ignition on, engine off) you put your finger on the sensor approximately 2 mm from the sensor. Put your ear close to the sensor. If you hear the sound of a soft knock, it means that the sensor is correct.If you dont hear that sensor is dead,
Unfortunately you will have to remove the bumper to replace the sensor
@@tehnicalife
Thank you for advise I’ve tried listening to all of them and no sound what so ever.
I gave this car to a you tuber to repair I’ll send you the link.
@@tehnicalife
ua-cam.com/video/m9PzY3Hs_78/v-deo.html
Could there be a fuse blown.
I’ve looked and can’t find any that’s related to sensors.
@@billplant2020 check the fuse and check that all the sensors are connected properly. One of them will not work if there is no connection, check the connectors and wires at the place where they come out of the car body. If the car was in an accident, the wires may be damaged. fuse diagram you have in the car book (manual book)
Hi, I followed all vedio to install the parking sensor. The bumper is not coming off. Does it come out with the crash bar?
After you release all the buckles and screws that hold it (including those under the taillights) you have to release it on the left and right. After that there is one sheet metal holder that holds it along its entire length along the trunk seal itself. Lift the complete bumper slightly upwards and it should come loose if you have done everything properly
worst rear bumper ever