Hi Leandro. Props on the content you are sharing. Do you know if I can do the same procedure to TM251MESC or TM251MESE controller? Is there a way to factory reset these controllers using EcoStruxure Machine Expert or any other software via direct connection (serial, Ethernet) without using a SD card?
Hi Wanderson! Unfortunately this process is only for the M251 dPAC use on EcoStruxure Automation Expert. The only "factory Reset" for the credential (in case we forget them) + code + ip setting for the TM251MESE/MESC is via SD card using the controller assistant: ua-cam.com/video/9InJbxTmGBY/v-deo.html If you know the credential of the PLC then you can use the controller assistant via USB cable or ethernet.
Рік тому+1
Congratulations on your videos, they are very educational. Thank you! I have a TM262 where a student in my class does not remember the password he set to access online from Machine Expert. I have followed your steps described in the video and the result is what happened to you. "return unknow command". Please, what can I do?
Hi Ricardo! this is only for EcoStruxure Automation Expert firmware of the PLC not for the ones programmed in Machine Expert. Please check the next video: ua-cam.com/video/QaI5ixQnB5o/v-deo.html
Hi Leandro. Props on the content you are sharing. Do you know if I can do the same procedure to TM251MESC or TM251MESE controller? Is there a way to factory reset these controllers using EcoStruxure Machine Expert or any other software via direct connection (serial, Ethernet) without using a SD card?
Hi Wanderson! Unfortunately this process is only for the M251 dPAC use on EcoStruxure Automation Expert. The only "factory Reset" for the credential (in case we forget them) + code + ip setting for the TM251MESE/MESC is via SD card using the controller assistant: ua-cam.com/video/9InJbxTmGBY/v-deo.html
If you know the credential of the PLC then you can use the controller assistant via USB cable or ethernet.
Congratulations on your videos, they are very educational. Thank you!
I have a TM262 where a student in my class does not remember the password he set to access online from Machine Expert.
I have followed your steps described in the video and the result is what happened to you. "return unknow command". Please, what can I do?
Hi Ricardo! this is only for EcoStruxure Automation Expert firmware of the PLC not for the ones programmed in Machine Expert. Please check the next video: ua-cam.com/video/QaI5ixQnB5o/v-deo.html