Most common problem if your brake lights wont turn off on your car , truck , or suv!
Вставка
- Опубліковано 7 жов 2024
- Howdy folks,
The other day, I walked out to my sequoia to find the battery totally dead. Once I jumped it, I noticed the brake lights were not turning off with the key out of the ignition. I noticed those green bits under the steering wheel and sure enough, it just needed that little plastic clip and VUALA! FIXED! Just thought I would share this with you fellow 1ste gen Toyota Sequoia owners! Below you will find the little plastic piece that will work on all 2001-2007 Sequoias and it comes in a pack of 10 so youre good if the replacement ever fails! Cheers all!
Brake pedal bump stop: amzn.to/3c5TOWr
Cracked me up when I looked at the floorboard and see the broken pieces of green plastic. Thank you so much.
What it called the part
Fantastic video. Suddenly I saw the break lights on at Walmart, I thought a faulty brake switch until I checked the brake pedal and saw an empty slot and a green plastic piece fell on the floor. Problem solved. Thank you very much.
This was so helpful. I fixed the problem. Here is another tip for those with the same problem - get a 'flip flop' and cut of the stopper from the underside. This stopper is exactly the right size. Strangely enough, I had cut one off only yesterday, so I took it to the car and it fit. So if you don't have the part, use that bit from the flip flop until you can get to a garage. 😘
I actually searched for where I can find my break light fuse, to turn off the light, instead I found this. This is the real, unerline issue I had. Thank you bro!
same 😂
Just spent 30 minute researching fuse diagrams lol. Here as well 😅
I also searched for fuse to shut off my brake lights and found this video and sure enough I found the broken plastic grommet. Thank you for posting this great trouble shooting video.
Omg! Thank you so much! I checked and that broken piece was all on the mat. Mechanics are close so I just put a part of the piece in position so the battery's car doesnt die. Thank you. Pura vida 🇨🇷
The same happened to me and I did the same😂
Sheeesh, thank you for the info. My rear lights were stuck on today and I looked down on the car mat and there was my issue. The piece broke off, easy fix. I’m glad we got UA-camrs like you. 🙏
Thank you that was exactly the problem😊 the part is called "brake pedal stop pad"
Thank you
Thank you!
preesh!
omg thanks so much
Saw the broken pieces on my floorboard this morning and thought it was broken candy , wow very helpful headed out to purchase the piece!
my dad came home today with the same problem. went on youtube and stumbled upon your video. saw pieces of broken plastic on the carpet under the brake. we put something in between for the meantime to turn the light off till we get that button type thing. thank you so much for this video
So many weird little quirks with these trucks, I had never heard of this one.
The Sequoia community is the best thanks for sharing!
Thank you. Just went to my truck to check it out, and I immediately saw the green plastic pieces on the floor mat.
Best video ever. Found the green pieces on the floor board. Save me so much time and stress. Thank you.
Very helpful, thanks so much. Found the broken gromet, found a replacement @ a local auto parts store, and after 10 min of angling under the steering wheel, I was able to push in the gromet! This saves me so much time and worrying about my battery before I could get to a mechanic. 🎉🎉🎉
It was about 11:30 at night on Saturday when my son saw his brake lights staying on. Your video gave me the temp fix needed until I could get the part or find a substitute. Thank you so much from a mom who is not a mechanic!
Thanks for the accurate and to the point description of the problem. Yesterday my brake lights on my 02 Sequoia would not turn off. So I spent a little time on the Internet trying to find the issue. And I only spent a little time because of your video. After watching it I walked back out to my car and there were the little green pieces on the floor mat.
Problem solved.
Thanks again for your time.
Awesome! I'm glad this video helped you out! If you havent yet, subscribe to our channel for more 1st gen sequoia content! Cheers
@@wasatchmotoco
I have subscribed and thanks again.
Just watched your video, as my 2004 Tundra brake light were staying on. After watching your video, went back to the truck and found those little green plastic pieces on the floor board. Now that I know how to fix, it will be easy peasy.
Thank you! Quick, accurate, and to the point. Perfect UA-cam video.
Thank you so much.. I have a 2002 honda crv and it did the same thing. Checked out your vid and it was that. I saw plastic parts on my floor mat. I put a piece of cardboard with tape until I stop by autozone to pick up the part.
Thank you!!! You are one of the few who actually showed both where the part goes AND how it gets installed. It might seem super obvious to most people, but I fix a lot of different stuff on my 2000 Corolla and it still wasn’t entirely clear what I needed to do to get the bumper in the right spot. I appreciate this video so much!
Went to my floor board and yes saw the green plastic buttons broke great vid thank you
Same situation here...I was headed to work, came out to start up truck, and had no power... ok I thought, get my battery pack charger and charge my battery. Didnt notice my brake lights were on until it became dark outside... Then I scratced my hea s puzzled to what waa was going on. Checked fuses like one would do first, all checked out... Searched out youtube and saw your video... I laughed so hard when you mentioned the little green plastic pieces... Thats exaclty what I saw on my floor board the afternoon before.... I thought it was something I stepped in and didnt think twice about it..... I piked up the pieces and threw them away.... Now I know.... I feel excited now.... Thanks for your video Sir....
wow man. Can't believe I found this video. Thank you! Its called a Brake Pedal Stop Pad. Thank you
Very helpful. I would have never thought to look there. I didn’t even notice there were pieces on the floor of my car until after watching your video. Thank You.
This just happened to me 2 days ago with my toyota echo. I replaced the battery thinking it was that. A co worker told me what this video explained at work last night and it made sense. Thanks
Ford Ranger 2006. Thank you for your information 🙏
2001' Toyota Sequoia: Thanks for a very clear and short video of the problem with solution. I bought the piece from O'rileys for &10 and installed it in 10 minutes.
This was so helpful! Brake lights on, looked for green parts--they were THERE! 2004 Tundra, 220k miles. Actually called local dealer, picked up part for $5 and my husband got it installed with a little help from me and your video. Thank you!
5⭐️ video! Excellent information. Went to local auto parts store and installed in less than 2 minutes.
Saved the day. I looked down and saw the little green pices
Why evry body is not like you simple helpfull . You are legend . Please more
Thanks for the help. We had the same issue, placed a small bolt, washer and nut. It solved the issue without purchasing a new spare part.
YOU ARE A GOD SEND FOR POSTING THIS. THANK YOU! 👏👏👏
Hey man all I’m going to say is thank you your saving a lot of money for people 🙏 god bless you
I can’t believe that this was actually the issue for my Santa Fe lol. I found the broken piece on my floor mat after watching this
Thank You!!! I couldn't figure out what was wrong...battery and starter motor I knew were good.
Yes, yes, yes-green pieces on my Tundra floor mat.....great video, short, to the point, and of course, accurate dx of the problem..thank you🛻
This just happened to me today in my 2003 tundra sr5 found the green plastic and everything thanks alot thought I was dealing with some electrical problem
Thanks. I fix my car after two days unplugging the battery every time i use it
I did replace with the rubber piece, but after about 2 years it wore down and the brake light kept coming on again. Then I replaced with the hard plastic piece ( similar to original) I think Auto Zone sells the kit with both rubber and hard plastic.. - may have to shave the hard plastic a bit like me to make it fit. That was 4 months ago, still working. I did this with the engine off and it was very difficult to do. So turn the car on as this video tells.
my brother in law turned me on to the little clear stick things you put on cabinet doors so they don’t slam! same thickness as the broken plastic thingy.. clean the metal bracket and stick it on.. perfect!
If it doesn’t stay for ever.. keep the rest in the glove box!
Thank you sir you are a huge help. My battery died overnight because of this exact issue and I was wondering what that green stuff on the floor was!
Thank you!!! you hit it right on the target. i was wondering where the green pieces came from and you explained it!
I had black crumbles on the floor! Fixed the issue for the night with a penny.
You are right! I was wondering what those little green plastics were. 😂
My Toyota t100 had the same issue and I been driving around trying to get a bump to get my lights working and I decided to go to UA-cam and first video
I came across and I went and saw my mat with some small tab that broke
Thank you so much this was also the problem with my car but instead of the rubber falling off , the little switch has dug a hole thru the rubber making it not press down!
Thank you for this post. We used a Mexican quarter for a temporary fix until we get replacement in, but exactly what you said the green pieces where on the floor
Exactly what you said is exactly what i had.
Thank you for this video! I am not at all a car person but i followed your video and it worked! 🙌🏻
Same thing happen to me I found my piece was broken , so I ordered some more spare grommets and popped it in and bam now my lights are off 😎
Great video. Just an fyi depending on your car the piece could be a clear rubber, my Acura TLX was.
HI, you video is short but very informative in how to put that little piece, appreciated for your video
I should have watched this video before taking it to the shop!
Your a life saver man!
Thanks for your assist! And I appreciated that you dropped the damn thing before you got it installed because, with my husband depressing the brake and me trying to push the button out of the way? The struggle was real. #truthinadvertising A few words might have been said before I finally got it seated under the switch so that it mounted. Whew! Car yoga accomplished!
My man I thought it had something to do with the break peddle and checked that before your video but didn't realize it needed that plastic there and what do you know I found that plastic your talking about! Thank you so much your the fucking man!
literal life saver ty so much i was dealing with the same problem
Reading comments is hilarious we all went through the same deal looking down at the floor mats lol Nissan rogue uses TAN plastic 😂
Thanks you and yes my issue ... easy fix except im in the philippines so had to make the part myself ... easy job though
Great video, that was exactly the issue! Thank you!
Thank you so very much for this video. I was starting to freak out, and God led me to your video. Sure enough, I see the green bits on the floor. Thank you, and God bless you🙏🏽
Thannkkkk youuuu.. it worked. Not sure why it also may have corrected an acceleration problem.
Thank you simple fix it also fixed my cruise control
Thank you. This is exactly the problem I have. The rubber plate is black on my car 2000 Corolla.
I have a 99 Camry found the pieces on the floorboard but they were brown. Someone left a comment they found them at a local auto parts store. The part is a brake pedal stop pad.
When seen that in the floor bord I thought someone been eating candy in my car and it was green lol but now I know what it was thanks for the info
Wow, this helped my 2004 Tundra. I am using electrical tape sticky side out until I can get the part ordered.
I saw the green plastic on the floor of my truck and laughed so hard
Thank you so much - this was my problem as well!!!
Thanks you vid was a big help
Saved me a heart attack... great vid
Thank you you saved me a bunch of time with this info!!
You saved us
God bless you
Exactly what the problem was. Thank you!!!
I have a 2003 Sequoia and this had me very worried. I went out and found the green parts all on the mat! Thank you! Kept jumping the car. I wish you could tell us the name of the part?
Check the description he put a link to the piece but I would say is a bit late now lol
Clutch Brake Pedal Stopper Switch Buffer Cushion Pad
That was exactly what was wrong! Thanks a bunch.
Bro. You made my day. I wish I could venmo you some $$ and buy you lunch. Thank you!
I have a 2005 Sequoia
This was the problem on my car, there were 2 brake stop pads I replaced both
Lights Off
Thanks for the show
awesome nailed it thats so weird to find bang on what ya want thankyou!
Amazing , thankyou for helping fix the problem 🎉
Very useful. Thank you....
Wooow awesome, thank you!
Much love 🎉
Thanks mate it helped
I couldn't figure it out. I watched the video and looked on my floorboard and seen 2 black plastic broken pieces laying under the brake pedal.
Earned a sub👍👍👍
Thank you brother.
Life saver
Save my night ❤
Thanks Bro!!
Thanks, this is good stuff
Thank you
❤ Thanks a lot, it happened to me just like in the video and it was a simple fix also
You're amazing.
Thank you
Thanks what a legend
Bravo !!
My go to 😂unplug the battery then hook it back up
Thank you for your help
Wow! Thank you
Nice video. That's my problem. Where is the link for the replacement part? Found it, decent price and installation was easy.
Worked like a charm 🤗