Couldn't have said it better myself, aside from cursing at it that is :) Whenever I get around to it I think my plan is to have the two hard lines from the floor dead end into a distribution block with soft lines going to the, well other soft lines but the external ones. Even though I don't see myself fiddling with those brake lines too often I don't like them and I want to make my own. Those sheet metal dimples are also really sharp. Thanks for sticking around Gafrers, it's always fun seeing where else I can find you on YT.
Not yet. It'll get featured as a side project in a later episode. The problem is it's just so difficult to get to the fasteners that hold the roll bar on. After a few hours of split knuckles, I was able to get them loose enough that I could slip a hacksaw blade under the roll bar and just cut it off. I'm currently drilling out the last bolt stuck in there. Thanks for sticking around!
You already strip em all thats dedication right there 🎉🎉🎉
Those internal lines really are "square peg in a round hole" case
Great work as always
Couldn't have said it better myself, aside from cursing at it that is :) Whenever I get around to it I think my plan is to have the two hard lines from the floor dead end into a distribution block with soft lines going to the, well other soft lines but the external ones. Even though I don't see myself fiddling with those brake lines too often I don't like them and I want to make my own. Those sheet metal dimples are also really sharp. Thanks for sticking around Gafrers, it's always fun seeing where else I can find you on YT.
@@Ludicrous_Speedway Nice Plan.
Thanks for the episode. Is there any episode/ time stamp to see the rollbar problem?
Not yet. It'll get featured as a side project in a later episode. The problem is it's just so difficult to get to the fasteners that hold the roll bar on. After a few hours of split knuckles, I was able to get them loose enough that I could slip a hacksaw blade under the roll bar and just cut it off. I'm currently drilling out the last bolt stuck in there. Thanks for sticking around!