Another great video, I had a similar issue the other week just before I came away on holiday, was getting the exact same issues but voltage was dropping to 10.2 at the main terminals T6&T7, but the error would only happen and then more frequently once it had been used for 20-30minutes, I used temperature gun on the bridge rectifier (the bottom one) and it was reading quite high and found that it was lose so fitted new crimps and then found that the microswitch had failed open circuit like yours, put temporary bypass and all seemed to be working but ran out of time to test more, but while sat here on sunbed and having watched your video I’m fairly confident the issue is solved but when I get back I will take a closer look at that terminal block and measure voltage there to. Love your tech blogs keep them coming 😊
Great video once again. I come across lots of power issues with corroded terminals, not very often on niftys , normally just bad Connections. We have a HR28 with very short connections from the main feed wire to the top box and no plug , just hard wired. Do you have a recommendation for the best way to extend them as the top can only be lifted a couple of inches
@@chriswoodridge7808 if possible I would advise against extending those cables as it runs canbus line through them . I would suggest to feed cable back to console as it possibly has been pulled back in to trunking . And I have seen some machines with Stuffing gland fitted instead of original one. That could be good idea as stuffing gland grabs on to cable and prevents from moving back in to trunking .
Another great video, I had a similar issue the other week just before I came away on holiday, was getting the exact same issues but voltage was dropping to 10.2 at the main terminals T6&T7, but the error would only happen and then more frequently once it had been used for 20-30minutes, I used temperature gun on the bridge rectifier (the bottom one) and it was reading quite high and found that it was lose so fitted new crimps and then found that the microswitch had failed open circuit like yours, put temporary bypass and all seemed to be working but ran out of time to test more, but while sat here on sunbed and having watched your video I’m fairly confident the issue is solved but when I get back I will take a closer look at that terminal block and measure voltage there to. Love your tech blogs keep them coming 😊
Great Video! Very helpful. I have the EXACTLY same issues on my Nifty SP50 Hybrid. Where are you located ?
@@DamianPoplawski-z8o thank you buddy I am located in UK 🇬🇧
Great video once again. I come across lots of power issues with corroded terminals, not very often on niftys , normally just bad Connections.
We have a HR28 with very short connections from the main feed wire to the top box and no plug , just hard wired. Do you have a recommendation for the best way to extend them as the top can only be lifted a couple of inches
@@chriswoodridge7808 if possible I would advise against extending those cables as it runs canbus line through them . I would suggest to feed cable back to console as it possibly has been pulled back in to trunking . And I have seen some machines with Stuffing gland fitted instead of original one. That could be good idea as stuffing gland grabs on to cable and prevents from moving back in to trunking .