If you're installing these on an RS, the bolts in the back are 8 mm instead of T30. Also, the RS rims are much larger so you can get away with leaving the front wheels on, but you'll need to get the bottom small screw threaded almost all the way into the bracket before putting the flap assembly on the car.
Great guide thanks. One small item to note is that the RS install does not require you to remove any of the circular clips in the rear arch liner.I also found it was easier to screw the bracket in starting at the top otherwise you struggle to get the spacers in place, other than that was a breeze thanks!
I put these on my 2014 se hatch after a stick flung from my wheel and dinged my door. They look awesome but just so you know if you dont have the ST, a little bit of the silver will stick out below your bumper so i recommend painting them black before hand
Just finished installing these...they look awesome! Along with 20mm wheel spacers all round. Front went on like butter, the back not so much. Make sure your long screws find the back of those plastic clips,there tricky. Also I ended up using one of the factory torx screws and clip on the inside hole instead of the push in clip. The hole was too big for the plastic clip.
For everyone asking, YES it works with the SE models and S model and Titanium. The only difference I can tell is that the ST comes with a longer rear bumper, as in it extends out to the wheels further, so when the flaps are installed on an SE or the like, you can see some if the bracket below the bumper, rear diffuser area. Only on the rear, though.
i have a 2015 focus st and for the rear you don't need to take the liner off as much as he did. You can install them without taking the top clip off and you'll be just fine.
Is there supposed to be a gap in between the rear fender and the mudflap? Mine have a gap and don’t know if it’s normal because of the spacers or If I did something wrong lol
Are you using any wheel spacers on the car shown? If the spacers are used does the wheel/tire stick out beyond the flaps? Thanks for all of the great vids on the ST.
I'm necro-replying here but hopefully this helps others. On the flaps you'll see the drilled holes are oblong, not circular. This is because you can camber the flaps inwards in outwards after you thread the screws in, so long as you don't snug them down immediately. I just installed mine yesterday and left about a fourth of an inch to each screw left to fasten down, and experimented with cambering the flap by grabbing the corners and slightly turning it inwards and outwards. I found where I wanted them, then snugged the screws down. All 4 hang perpendicular to the ground. There have been quite a few FoST and FiST owners I've seen with negatively cambered flaps because they didn't adjust theirs before snugging them.
Yes, they both have the same exact liner set up and same line up for all the bolts. I had the SE model and now I have an ST, transferred Rallyarmor mudflaps from the SE to my ST
Just installed mine. Nice little design, definitely a functional product outside of its aggressive looks. To everyone that's installing them, are you aligning the flaps like it says in the manual? Or are you just aligning them to what positions looks the best to your own eye?
Just installed these on a 2014 Focus SE. The seller said they would fit but they do not. I'm guessing the ST bumper sets lower to the ground. the bottom of the bracket is exposed and looks terrible.
We are going with a set of KW coilovers for our car. We do not offer the mountune springs so I really can't offer an opinion on them. I was happy with the Eibachs we installed on the 13, they rode nice and had a nice stance.
"2013+ Ford Focus ST, SE/Titanium Hatch models." That'd be a yes. Just picked up a 14 SE hatch and already planning on ordering a set, and Weathertech floorliners. Gotta keep that paint chip free and the carpet spotless.
Da Blueguy i gave up on the price and just got the one's from ford. they are half as cool and half as expensive so i dont mind. the 14 se is a solid car! just got it a month ago. ST would have been fun, if i had the money...
My WRX was a lot more fun, but I'm gonna enjoy filling this up a lot less. So I wouldn't dwell on it too much, as this supposed 'cheap gas' won't last after election season.
Those are the Niche Targa 18x8 that we sell here at CJ Pony Parts. www.cjponyparts.com/niche-targa-wheel-18inx8in-40-offset-matte-black-with-tinted-face-accents-focus-st-2013-2014/p/W635-V/
@@codyreekie LoL right... The rear wheels will still pick up debris and fling them into the paint... Even though AWD will obviously cause even more debris
If you're installing these on an RS, the bolts in the back are 8 mm instead of T30. Also, the RS rims are much larger so you can get away with leaving the front wheels on, but you'll need to get the bottom small screw threaded almost all the way into the bracket before putting the flap assembly on the car.
Great guide thanks. One small item to note is that the RS install does not require you to remove any of the circular clips in the rear arch liner.I also found it was easier to screw the bracket in starting at the top otherwise you struggle to get the spacers in place, other than that was a breeze thanks!
I put these on my 2014 se hatch after a stick flung from my wheel and dinged my door. They look awesome but just so you know if you dont have the ST, a little bit of the silver will stick out below your bumper so i recommend painting them black before hand
Just finished installing these...they look awesome! Along with 20mm wheel spacers all round. Front went on like butter, the back not so much. Make sure your long screws find the back of those plastic clips,there tricky. Also I ended up using one of the factory torx screws and clip on the inside hole instead of the push in clip. The hole was too big for the plastic clip.
what are those rims????
For everyone asking, YES it works with the SE models and S model and Titanium.
The only difference I can tell is that the ST comes with a longer rear bumper, as in it extends out to the wheels further, so when the flaps are installed on an SE or the like, you can see some if the bracket below the bumper, rear diffuser area. Only on the rear, though.
i have a 2015 focus st and for the rear you don't need to take the liner off as much as he did. You can install them without taking the top clip off and you'll be just fine.
Thanks for the heads up, we thought that might be possible but took it further apart so people could see better.
@@cjponyparts Definitely great video, just wanted people to know you don't need that extra piece taken off. Then again it could also make it easier.
I'm definitely getting these for my winter setup.
What are those wheels and red bolt on them (sorry for my english)
Just bought 1 red st here in belgium
Still helpful in 2019. 🤣
Jess there are no spacers on our car, that is stock track width
Is there supposed to be a gap in between the rear fender and the mudflap? Mine have a gap and don’t know if it’s normal because of the spacers or If I did something wrong lol
Are you using any wheel spacers on the car shown? If the spacers are used does the wheel/tire stick out beyond the flaps?
Thanks for all of the great vids on the ST.
you think these would fit a 2017 ford focus se sedan?
so these require no cutting or permanent modifications yet require me to hack a hole through the rear wheel liners?
Extremely well made tutorial. Thanks!
I installed them the front hangs straight down, and the backs are super curved what happened?
I'm necro-replying here but hopefully this helps others. On the flaps you'll see the drilled holes are oblong, not circular. This is because you can camber the flaps inwards in outwards after you thread the screws in, so long as you don't snug them down immediately.
I just installed mine yesterday and left about a fourth of an inch to each screw left to fasten down, and experimented with cambering the flap by grabbing the corners and slightly turning it inwards and outwards. I found where I wanted them, then snugged the screws down. All 4 hang perpendicular to the ground.
There have been quite a few FoST and FiST owners I've seen with negatively cambered flaps because they didn't adjust theirs before snugging them.
are these the longer or the shorter flaps? wondering if they will fit on my focus with a drop.
Can the front mud flap go inside the fender liner
Just put a pair of these on my 2016 ST.. there is a bit of a gap between the rear mudflap and the actual body. Is that normal?
It should be pretty tight but a hint of gap is normal
hi, i have a 2014 ford focus 2.0 S hatch, can it be fitted with this ST model flaps?thanks
Yes, they both have the same exact liner set up and same line up for all the bolts. I had the SE model and now I have an ST, transferred Rallyarmor mudflaps from the SE to my ST
Pat Almeida Pat do these fit on a 2014 se hatch?
will they fit se model's that are non hatch backs?
Just installed mine. Nice little design, definitely a functional product outside of its aggressive looks. To everyone that's installing them, are you aligning the flaps like it says in the manual? Or are you just aligning them to what positions looks the best to your own eye?
Just installed these on a 2014 Focus SE. The seller said they would fit but they do not. I'm guessing the ST bumper sets lower to the ground. the bottom of the bracket is exposed and looks terrible.
JBart812 it says st and rs in the title not se
My car is on sport line lowering springs will these still work ?
Still helpful in 2022. 😁
What springs are you going to go with? I would love your opinion on the mountune springs if that's an option for you guys.
We are going with a set of KW coilovers for our car. We do not offer the mountune springs so I really can't offer an opinion on them. I was happy with the Eibachs we installed on the 13, they rode nice and had a nice stance.
Do these fit on non-ST Focus?
Yes, these will fit 2013-2014 Focus SE/Titanium Hatch models
so this will fit at my 2013 titanium hatchback
The fps on this video is orgasmic *__*
Also wonderful explanation, thank you!
what type of mods i can put on my 2018 focus se hatchback.
is this pretty much the same process for a 2017 focus st?
Exactly the same. The rally armor flaps run from 2012-2018 Ford Focus ST
same fitment and installation for 2016 models?
Yes
So would these fit on an SE as well??
Yes all hatchback models 2013 up
yes all mk3-mk3.5 (2013-2018)
Would this fit a 2012 Ford Focus titanium?
According to Rally Armor, yes they do
Would I be able to install these on a 2011 Jetta?
P MO yes
Does this work on a 2010 Ford Focus?
no
To mudflap or not to mudflap, that is the question.
Will these fit a 2012 SEL hatch?
Vince Stinnett buy it and see for yourself lazy bones
how do you secure the last screw
Lol
does anyone know if i can use these on the SE model? i'm assuming no but its worth the ask.
(2014 se hatchback)
"2013+ Ford Focus ST, SE/Titanium Hatch models."
That'd be a yes. Just picked up a 14 SE hatch and already planning on ordering a set, and Weathertech floorliners. Gotta keep that paint chip free and the carpet spotless.
Da Blueguy i gave up on the price and just got the one's from ford. they are half as cool and half as expensive so i dont mind. the 14 se is a solid car! just got it a month ago. ST would have been fun, if i had the money...
My WRX was a lot more fun, but I'm gonna enjoy filling this up a lot less. So I wouldn't dwell on it too much, as this supposed 'cheap gas' won't last after election season.
Da Blueguy 30 mpg on my first tank of gas, im pretty happy! But yes, a wrx would be way more fun. Yeah... stock up now!
What wheels are those?
Those are the Niche Targa 18x8 that we sell here at CJ Pony Parts.
www.cjponyparts.com/niche-targa-wheel-18inx8in-40-offset-matte-black-with-tinted-face-accents-focus-st-2013-2014/p/W635-V/
Mine aren't glossy anymore. :(
Will they fit 14 plate zetec s
They fit the ST, SE, and Titanium models
That much money an they can't even powder coat the metal.
Eh - pass :) Nice install video as always though. Loved the model lift in the tools clip.
thanks for nothing great video
its not all wheel drive...
Alpha Wolf and?
@@codyreekie LoL right... The rear wheels will still pick up debris and fling them into the paint... Even though AWD will obviously cause even more debris
hi would they fit my 2015 ford focus sport.
do these work on the 2017 st?
luis paredes nothing much has change besides the front so yes they will fit
what wheels are those?
Andrew xxr