Hawa ghus gaya hai bro. Mera bhi hua tha. Cooling system ke andar hawa chala gaya hai. In steps ko follow karo. 1. Open left side black pipe and right side's front lower pipe. Also empty the reservoir by removing the lower hose. And lastly remove the radiator cap 2. Drain all coolant and remove the 8mm nut on the front side of the engine block, coolant will come from there also. 3. Now put all the hoses back on its place, except the bolt on front of the engine block Slightly tighten that bolt as you will have to lose it again 4. Now fill the coolant directly in radiator upto radiator cap 5. Press the pipes and you will see bubbles coming out from radiator, fill again and repeat the same. Now slowly losen that nut on the block. once the coolant starts coming out from that nut, tighten it 6. Now start the engine and wait for it to heatup. 7. On the left side of the engine you can see there is coolant inlet with 4 Allen key nut. Slowly loosen the top nut and make sure coolant is coming out from it, throughout the whole process keep the radiator full always. Now tighten the nut and you're done
😮
👍🙌
❤
This is not good way yo drain the coolent bro
Reservoir tank tu clean hi nahi howa aur fillup bhi nahi hua. Half work done bhai
Already done ✅ bro
Sirji reservoir me coolant nhi dalenge kya?
Already done
Bro mere bike ka fan continue chalraha hai or heating light b araha hai coolant b boil nahi hora
Gas kit Gaya bro 🙌
There will be air lock on your radiator
@@SRCrazyvlogsbro use the drain bolt to release the old coolent
Hawa ghus gaya hai bro. Mera bhi hua tha.
Cooling system ke andar hawa chala gaya hai. In steps ko follow karo.
1. Open left side black pipe and right side's front lower pipe. Also empty the reservoir by removing the lower hose. And lastly remove the radiator cap
2. Drain all coolant and remove the 8mm nut on the front side of the engine block, coolant will come from there also.
3. Now put all the hoses back on its place, except the bolt on front of the engine block
Slightly tighten that bolt as you will have to lose it again
4. Now fill the coolant directly in radiator upto radiator cap
5. Press the pipes and you will see bubbles coming out from radiator, fill again and repeat the same. Now slowly losen that nut on the block. once the coolant starts coming out from that nut, tighten it
6. Now start the engine and wait for it to heatup.
7. On the left side of the engine you can see there is coolant inlet with 4 Allen key nut. Slowly loosen the top nut and make sure coolant is coming out from it, throughout the whole process keep the radiator full always.
Now tighten the nut and you're done
Bro mra fan slow high hora h heating k bd any suggestions?
Dm me on INSTAGRAM SR CRAZY VLOGS 👍