Okay when do we get the full Klipper tutorial for the SE 😯 Really nice upgrades you did so far but without input shaping what are we compared to the Bambu guys
@@Hy6oTpax пружины использовал со старого Anet A8, можно посмотреть на алике... Единственное я брала на Али для стола но они на столько жёсткие что стол выгибают, по этому взял со старого принтера, я думаю не проблема найти что-нибудь подходящее
I did the same, but with a thumb nut at the bottom, so that allows me to adjust. Getting below 0.1 on all sides. Wish there was a fix for Z offset that was that easy.
Okay when do we get the full Klipper tutorial for the SE 😯 Really nice upgrades you did so far but without input shaping what are we compared to the Bambu guys
Great videos 🎉🎉🎉
Why the left rubber had differents sizes ?
Could you write here the sizes ?
Cheers
Я заменил на пружины, после настроил и забыл как страшный сон, пружинки лучший вариант
Что за пружины? Где то купили?
@@Hy6oTpax пружины использовал со старого Anet A8, можно посмотреть на алике... Единственное я брала на Али для стола но они на столько жёсткие что стол выгибают, по этому взял со старого принтера, я думаю не проблема найти что-нибудь подходящее
I did the same, but with a thumb nut at the bottom, so that allows me to adjust.
Getting below 0.1 on all sides.
Wish there was a fix for Z offset that was that easy.
I love your videos.
Me too
Loosen the screws
Heat the bed
Slowly tighten the screws
Metal expands when hot, so if you snug it down cold, it is guaranteed to warp!!!