Pro tip clean and grease your caliper bracket slide bolts for longer pad life. You can also freeze your new bearing for a few hours before pressing it in if you have the time. It will shrink and should press in easier and be less likely to jam being pressed in. U joints and ball joints almost fall in in comparison.
Is it okay if the hub you installed after the new bearing wiggles in the bearing ? I haven't torqued the axle nut yet and the bearing sits tightly with the c clip installed. I just put two new bearings in and both of them had the same problem.
I like the video. You never put high heat lube on the brake pads where they slide. You should mention to check and clean caliper sliders, check caliper to make sure piston goes in easy so you can have room for new pads. All good. My buddy did what you did but sliders were sticky and he had a problem putting new pads in. He was trying with out pressing incaliper piston. He was also forcing in a siezed piston. Good thing i caught him so he could check everything before completing this.
√ Watch the Video
√ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts
√ Do it Yourself
√ Save Money
Where can I get the bearing tool for this job at?
I love how smoothly you’re able to remove parts in your videos lol. Just spent 15 minutes trying to get my seized ball joint loose🤗🤗🤗
Pro tip clean and grease your caliper bracket slide bolts for longer pad life. You can also freeze your new bearing for a few hours before pressing it in if you have the time. It will shrink and should press in easier and be less likely to jam being pressed in. U joints and ball joints almost fall in in comparison.
Is it okay if the hub you installed after the new bearing wiggles in the bearing ? I haven't torqued the axle nut yet and the bearing sits tightly with the c clip installed. I just put two new bearings in and both of them had the same problem.
I like the video. You never put high heat lube on the brake pads where they slide. You should mention to check and clean caliper sliders, check caliper to make sure piston goes in easy so you can have room for new pads. All good. My buddy did what you did but sliders were sticky and he had a problem putting new pads in. He was trying with out pressing incaliper piston. He was also forcing in a siezed piston. Good thing i caught him so he could check everything before completing this.
You Sir are a Pro! This video has excellent content! Well done! A+
Lovet ,AWESOM ... GOOD QUALITY VIDEO ...LOOKS VERY CLEAR ...THANKS GUYS FOR SHARING.
+@josediaz8994 Thanks for the feedback! 1aau.to/m/Shop-TRQ
We're you get the press that you use for with the wrench gun?
Which direction does the bearing go I have 02 civic ex with abs
Fantastic video !!!
감사합니다
What snap ring pliers. I can not get the clip in to save my life