Ford Expedition INTERIOR LED Swap | 2007 to 2014 Expedition | Dome Light Replacement
Вставка
- Опубліковано 14 бер 2022
- In this video I'm going to show you how to install led lights into the interior of your 2007-2014 Ford Expedition. This was a quick how to because I quickly learned there were a few tricks that you need to know to get it done. If you have any questions be sure to send a comment and I'll help you out!
- Авто та транспорт
Thanks for making this video! Made my life way easier.
They are no fun! Glad it helped!
You just saved me a ton of time. I appreciate you
Glad I could help out!
Thank you thank you.. you saved me a ton of time.... I just used a small Alan wrench. 2007 expedition here.
Heck yeah glad it helped!
I also have 2007 Expedition Eddie Bauer model and I cant figure out how in the world to change out the visor vanity bulbs....!! I cant find anyone that has the same kind of vanity mirrors that i have...
Did you change yours? Can it be done? Please help!!
Thank you!
Just did my 2014 Navigator, discovered complete removal unnecessary (accidentally). Access the tabs behind glasses holder using plastic blade that came with bulbs kit just remove the light cover by releasing the tabs and the moon roof switch cover by its tabs. Using needle nose pliers grab the bulb gently and wiggle it while pulling on them and they will easily pop out. Use pliers to install led bulbs with correct polarity. Caution: old bulbs will be HOT so have a safe place to put them where they will not melt or burn anything. Fortunately I had the AC on so I held them in front of the vent for a few seconds and they cooled quickly. The middle map lights have the tab you mentioned but it is offset from the center one. Using a special tool (butter knife) it popped out easily and again removed bulbs with pliers. The rear one at the lift gate is a different animal, nothing easy about it so, good luck on that one. Hope this helps. Blessings! 😉
I was scared I was going to smash the bulbs with my pliers so if you got em good job haha the rear ones weren't built to be replaced
Thank you! Merry Christmas!
You're very welcome! Merry Christmas and Happy New Year to you too!
Thank you!!!!
Glad it helped!
Thank you 🙏🏼!!!!!!!
Glad it helped!!!
Thank you sir, appreciate it.
Glad it helped!
Easy peasy, just did it. Thank you for your guided assistance. Now if only I could figure out my vanity bulbs!?!?
😊
I still have a few more to figure out too! Glad it helped!
Great video, can you please share the link to the lights? cant seem to find them.
Just go on ebay and search for Expedition LED interior lights and get one of the kits
Excelente 👌
Hope it helped!
OR .... OR .... one can remove the entire light/glasses case assembly, which is only held in by tension clips and pulls right out without the risk of breaking tabs.
That might be easier but I haven't tried that!
What about wrapping duct tape on the bulbs and pulling them out instead of removing the whole housing?
That's smart right there! I'll have to remember to try that one!
Are the led bulbs you installed dimmable?
I have no idea. I don't think there is even an option to dim them.
What bulbs did you get, like code wise?
I just got a whole kit off of ebay for the expedition that came with everything. It even had a few extras if you need them.
# 194 size should fit
I 👀 you!!
Let's go!