Škoda Fabia Mk2 5J Electric Window Switch Teardown and Repair

Поділитися
Вставка
  • Опубліковано 8 вер 2024
  • A guide on how to remove and repair the electric window switch on a Škoda Fabia Mk2 / 5J (2007-2014).
    Please note the procedure is different if the car is fitted with rear electric windows.
    The switch in question was intermittently faulty, occasionally it was impossible to roll the window down altogether.
    Apologies for the occasional baby noises in the background!

КОМЕНТАРІ • 69

  • @michaelachenbach8473
    @michaelachenbach8473 2 роки тому +2

    Many thanks, I just fixed our Roomster in the same way, works perfect!

  • @georgebradshaw1422
    @georgebradshaw1422 7 років тому +2

    Just want to say I had the same problem because I left the drivers side window open last week. Thanks to your tutorial I bought a new switch on EBay for £14.50 and fitted it in ten minutes this morning. Thanks again.

    • @derekbrooks6854
      @derekbrooks6854 7 років тому

      Goerge Bradshaw - I'm looking at a switch for £8.50 on ebay but am a bit worried about the quality. If yours is ok, any chance of a link please?

    • @mekydro
      @mekydro 6 років тому

      www.ebay.co.uk/itm/122725240278
      I found this switch to be the same 'made in Italy' switch as the original - worked fine when fitted

    • @peterstubbings7978
      @peterstubbings7978 6 років тому

      George Bradshaw ik

  • @lttlstory
    @lttlstory 2 роки тому +1

    Well done mate, worked a treat. I used an old toothbrush and some vodka. Cleaned up the silicone area, dried it off quickly. Remember not to rehouse everything straight away. Just get the switch assembled, reconnect it to the electrical system and just check the windows will go up and down.

  • @TrueSkyl1n3
    @TrueSkyl1n3 5 років тому +4

    I finally got round to doing this on my vRS and they work perfectly now!! For the first time in 3.5 years 🥳

  • @mekydro
    @mekydro 6 років тому +1

    Many thanks for putting this video up. I found that it is not strictly necessary to remove the door trim parts; by using a flat rounded lever I was able to lever the switch out using that alone (and it didn't mark the surrounding trim). I used a tool that I originally bought for removing watch casings, it is perfect for this too. Switch took less than 5 minutes to change - a real result!

  • @jimmy66603
    @jimmy66603 3 роки тому +1

    Nice one. Cheers for taking the time to make this tutorial clip. My wife had the same problem with the front windows on her fabia. I watched your video, scribbled down some notes,...and followed exactly what you did. Guess what....?? It worked..!! The twin master switch was faulty, and so was the single switch on the passenger door. I used nail varnish remover to clean the contacts cos its May bank holiday and that's all I had available to me. I really appreciate your time and effort in sharing this excellent quick fix.

  • @richardlees9080
    @richardlees9080 4 роки тому

    Thank you. Managed a temporary repair and close the drivers door window. New switch ordered as the corrosion was bad.

  • @hyoga1234
    @hyoga1234 Рік тому +1

    Thanks for your help. Now i'm could fix the window dispositive

  • @MS-fj9dn
    @MS-fj9dn Рік тому

    Thank you for this video. Saved me 40quid! In my case the cable was not properly in the switch box. Many thanks brother🙌🏽🙌🏽🙌🏽

  • @campione9
    @campione9 7 років тому +3

    Thank you very much
    Your video encouraged me to repair my car switch myself, and I did. Cheers.

    • @derekbrooks6854
      @derekbrooks6854 7 років тому +1

      Exactly :) I just said the same to my missus when I told her I was going to try to fix her non-working window switch :)

  • @wmlmike25
    @wmlmike25 Рік тому

    Thanks it works after following your video and finding the right switch on Amazon.

  • @larsguitar
    @larsguitar 2 роки тому +1

    Great video! You just saved me a good deal of money and a whole lot of time. Thanks!

  • @zenoelea8239
    @zenoelea8239 4 роки тому

    Did my 2004 Polo 9n switch. Different internals but used toothpaste to clean off the burning damage and polish the contact surface as contact cleaner was no very effective. Now works fine.
    :)

  • @endima6204
    @endima6204 5 років тому +1

    Thank you pal! I managed to fix my windows and mirrors!!!

  • @judithturner2463
    @judithturner2463 6 років тому

    Thankyou so much for putting this video on, fixed my very corroded VW Touran switch using your guide. Very pleased

    • @theweekthatis
      @theweekthatis  6 років тому +1

      That's great, I'm glad it worked well on a Touran too.

  • @muratkebap9617
    @muratkebap9617 7 років тому

    Thank you for your detailed explanation. I had same problem and i repaired this switch by watching your video

  • @crabsodyinblue
    @crabsodyinblue 2 роки тому +1

    thanks for this. i replaced mine in a fabia mk1 but the cheap new one doesn't operate in two-way switch mode, even though it has a two-way switch feel to it. it also seems like it is the masterswitch to the pax side switch, as that one isn't replaced but now also not two-way anymore. might be the cheap (€15) replacement doesn't have the logic.
    So i'll try and follow your instrcutions to clean/repair the original one.

  • @rxs1967
    @rxs1967 2 роки тому

    Thanks for this video .. helped me sort out the exact same issue with the secondhand Fabia I just bought :)

  • @andymiles5156
    @andymiles5156 4 роки тому

    I have the same issue with a 2010 Fabia. I can hear a metallic rattle in the door but that must be something else. Will have to give it a go, thanks.

  • @adi274
    @adi274 3 роки тому

    I just tried this myself but could not stand the idea of jamming a screwdriver to remove the actuator from the plastic part and potentially damaging the plastic, which I am not really able to find easily in my area. Thus, I tried to slide 4 toothpicks in between the two plastic knobs on each corner of the actuator, distancing the actuator from the plastic housing. After that, I firmly pressed down on the window open/close buttons, until the actuator was ejected out of the housing, admittedly with high velocity. The plastic housing had 0 damage on it. I did do this on a warm day, so the plastic was kind of soft, so it had a little give. Put in a new switch, works like new.

  • @659nickg
    @659nickg 2 роки тому +1

    I found it wasn't necessary to remove the door handle part as I just levered up the switch & it popped out nicely.
    This was on a Roomster, but I'm sure they're the same.

  • @petedougan5682
    @petedougan5682 3 роки тому

    Very well put together video. Very helpful. Thank you

  • @SpannerAT34
    @SpannerAT34 3 роки тому +1

    Great narration - thank you.

  • @dandare5141
    @dandare5141 Рік тому

    Thank you very much.
    Repaired switch.

  • @canberkana
    @canberkana 6 років тому

    Hey there. I've fixed my car following your video. Thank you for saving me from going to the repair shop.

    • @theweekthatis
      @theweekthatis  5 років тому

      Brilliant to know I could help, thanks for commenting!

  • @MrBaxyHUN
    @MrBaxyHUN 3 роки тому +1

    Thanks for the help!

  • @derekbrooks6854
    @derekbrooks6854 7 років тому

    Thanks for taking the time to share this.

    • @theweekthatis
      @theweekthatis  5 років тому

      Thanks for taking the time to comment :)!

  • @lafemmelaMon
    @lafemmelaMon 3 роки тому +1

    I left the passenger window open and the switch got wet now won't open, will do that tonight. Thanks.

  • @nPCHL
    @nPCHL 3 місяці тому

    Thanks 🙂

  • @andynightingale7335
    @andynightingale7335 Місяць тому

    These window switches are on Amazon, plenty of sellers. About £10. And if its not the switch that's faulty you can always return it and just say you bought the wrong one.

    • @theweekthatis
      @theweekthatis  Місяць тому

      They are now, but there weren’t 8 years ago.

    • @andynightingale7335
      @andynightingale7335 Місяць тому

      @theweekthatis yes m8 appreciate that. I just mentioned it in case anyone wanted to attempt this and wanted a cheap option to try (like me tomorrow. :) )

    • @theweekthatis
      @theweekthatis  Місяць тому +1

      @@andynightingale7335 still not as cheap as a bit of contact cleaner though 😜

    • @andynightingale7335
      @andynightingale7335 Місяць тому

      ​@theweekthatis thanks for the video showing removal. Swapping out the switch today has worked and my dad can use the driver door window again. Cheers.

  • @HektorBandimar
    @HektorBandimar 3 роки тому

    Good video, useful info, thanks for posting, I'm curious to know if the drivers window juddered when you tried to move it up and down?

    • @theweekthatis
      @theweekthatis  3 роки тому

      Not at all.

    • @HektorBandimar
      @HektorBandimar 2 роки тому

      @@theweekthatis thanks, I actually meant, was it juddering up before you fixed it? I'm trying to do this now, but I find the door handle difficult to coax off, don't want to bust it. :-)

  • @lordan6909
    @lordan6909 2 роки тому

    Hello sir where can I buy that switch panel ?

  • @Sten_Takens
    @Sten_Takens Рік тому

    Hi, i also have a fabia (2011) qnd now the window has his own life (goes up and down) if i do the window all the way down it comes right up, you think this is the same problem?

  • @user-xv6kw4re4s
    @user-xv6kw4re4s 4 роки тому +2

    Good video, but too many words.

  • @akz2204
    @akz2204 5 років тому +1

    Fell asleep after 5:00 min 😴😴😴

    • @grandadsworld7623
      @grandadsworld7623 3 роки тому

      RE WINDOWS JUDDERING NORMALLY DUE TO HEAT EXPANSION, SPRAY WINDOW RUNNERS WITH SILICONE LUBRICANT SPRAY.

  • @WiresFanDrew
    @WiresFanDrew 4 роки тому

    There is no perhaps...... yes you did mark it!

    • @theweekthatis
      @theweekthatis  4 роки тому +1

      Basically wrote the car off after that :(

  • @stephenwarrington2020
    @stephenwarrington2020 6 років тому

    Side panel wont lever off. Steve

  • @MrManuel55555
    @MrManuel55555 5 років тому

    uma grande ajuda para os mais leigos na materia...mas...esse interruptor tem 2 resistencias para informaçao do sinal de descida ou subida ao modulo do motor de
    levanta vidro.
    se uma resistencia estiver com defeito nao adianta limpeza.
    m.ua-cam.com/video/MsKSoj3d3sA/v-deo.html
    enjoi...

  • @RichardEvans-eg5sk
    @RichardEvans-eg5sk 4 місяці тому

    Or by a new switch from Amazon for £8!

    • @theweekthatis
      @theweekthatis  4 місяці тому

      Have you ever thought that when I made the video they were not £8 on Amazon?

  • @WiresFanDrew
    @WiresFanDrew 4 роки тому

    “I’ve slightly damaged it but it was bad quality.......” really.....!!!!

  • @ibhatti19
    @ibhatti19 2 роки тому

    Get to the point too much waffling