3:05 Combining. My combining window only showed up when selecting all. How do i select just the two? I clicked on the inside, then held down cntrl to click on the outside. what am i doing wrong?
Did you break the contour group apart, and then make sure they are ungrouped? If you do that, you should be able to have 2 totally separate pieces. Move them away if necessary to check. Select them both and then see if the combine tool comes back.
At 2:48 after ungroup all, how do to select the 2 layers? You just click the first layer then click the 2nd layer or should we click on first layer then press 'ctrl' or 'shift' key to select the 2nd layer?
I created the shortcut manually for the Enhanced and Wireframe mode. Go to Tools->Customization->Commands and then you can make a shortcut. I use w for wireframe and q for enhanced mode.
Thanks a lot, my app is a bit different from yours so i was actually lost on the way, but it was helpful ❤
Thanks for this. I was just thinking of how to do this, before I found this.
Thanks alot
Thank you brother
3:05 Combining. My combining window only showed up when selecting all. How do i select just the two? I clicked on the inside, then held down cntrl to click on the outside. what am i doing wrong?
Did you break the contour group apart, and then make sure they are ungrouped? If you do that, you should be able to have 2 totally separate pieces. Move them away if necessary to check. Select them both and then see if the combine tool comes back.
Thank you for create this video !
Thank a lot. This was very helpful for me ;)
How do you solve contour offset is too large?
Start with a smaller value, then try the contour again. It could be that the value you are using is too large.
At 2:48 after ungroup all, how do to select the 2 layers? You just click the first layer then click the 2nd layer or should we click on first layer then press 'ctrl' or 'shift' key to select the 2nd layer?
Mine wouldn't show the up-group option. Anyone know why?
Thank you
very nice
why did you not explain how to toggle between wire frame option
the keyboard short cut you clicking
I created the shortcut manually for the Enhanced and Wireframe mode. Go to Tools->Customization->Commands and then you can make a shortcut. I use w for wireframe and q for enhanced mode.