All your s2000 videos have been awesome. For extending your positive battery cable does it get ran through the fender side as well or did it go through the engine bay?
If your blowing fuses it's because there is an issue with wiring or a component you have to address anyway so you will be working on the car. Also the way it is positioned all you have to do is turn the wheel and pop a couple plugs and you can pull the liner over and gain pretty easy access. Plenty of cars put the battery in the fender well and if your car is factory or your electronical work is clean you would be more likely to replace a battery than a fuse. Been over 2 years. Haven't been back in the fender since I put it in there.
All your s2000 videos have been awesome. For extending your positive battery cable does it get ran through the fender side as well or did it go through the engine bay?
Thank you!! Just ran it through the firewall where the harness comes through 👍👍
Sub and ready for more vids.
Did you extend all the wires with 8 or 10 gauge?
Hey man just a quick question! what gauge wire did you use?
what is the wire that runs along the top of the firewall into the fender area that comes from behind the engine?
Just imagine if you blew a fuse, gotta take that fender out every time.
If your blowing fuses it's because there is an issue with wiring or a component you have to address anyway so you will be working on the car. Also the way it is positioned all you have to do is turn the wheel and pop a couple plugs and you can pull the liner over and gain pretty easy access. Plenty of cars put the battery in the fender well and if your car is factory or your electronical work is clean you would be more likely to replace a battery than a fuse. Been over 2 years. Haven't been back in the fender since I put it in there.
@@ericmorgan1256 you just cut a huge hole on the corner of the engine bay?
@@EmanuelMarquez-z5l no, used factory holes that were already there. Only used drill bit to puncture factory grommet to feed main battery wire.
@@ericmorgan1256 on the side rail you turned the harness from the firewall onto passenger side? Like you didn’t pull the dash out?
What did you use to extend the eps wires
8 or 10 gauge wire will work, then solder and heat shrink the connections. 👍