Kia Joice | Bi-Xenon HID Projector & Angel Eyes Headlight Upgrade installation
Вставка
- Опубліковано 5 сер 2024
- In this video we show you how to build a regular family car into a pretty rough one! With dimmable Angel eyes as Daytime Running Lights and position lights, in perfect combination with the Mini H1 bi-xenon projectors with the best bulbs available on the moment, the XB35 5500K H1.
𝗬𝗼𝘂 𝗰𝗮𝗻 𝗯𝘂𝘆 𝘁𝗵𝗲𝘀𝗲 𝗽𝗿𝗼𝗱𝘂𝗰𝘁𝘀 𝗵𝗲𝗿𝗲:
Mini H1 Twin Kit: retrofitlab.com/products/kia-...
Angel Eyes: retrofitlab.com/products/ange...
𝗜𝗻𝘀𝘁𝗿𝘂𝗰𝘁𝗶𝗼𝗻𝘀:
0:00 Halogen view before we retrofit the Kia Joice
0:08 Remove the clips on the glass and housing by a flat screw driver and heat it in the carton box for about 15 minutes
0:34 When the headlight is heat enough you can open it pretty easily with a flat screw driver, and press the glass of the housing
0:53 Unscrew the inlay to get by the reflector
1:16 Unscrew the bulb holder from the back side so the Mini H1 projectors tail can trough the opening
1:25 Don't forget the rubber ring on the tail, and lock the projector from the back with the included centric ring and nut
1:41 Screw the bulb holder on the tail of the bi-xenon projector and connect the H1 high beam splitter
2:17 Back to the front, you'll put the centric ring on the projector and press the Iris shroud on it (you can use some extra glue for secure fitment)
We've mount an SMD Angel Eye on the Iris shroud and use that as city lights
2:36 Put back the inlay and lock it by the screws again
2:52 Mostly extra butyl isn't needed here, but to be sure we put some extra new grey butyl in there, press it in the housing
3:16 Press the glass back on the housing and heat it again for about 15 minutes in the carton box
3:31 When it's heated the glass slides in the housing when you press a little, lock it with some clamps and let it cool down and press the clips back on the housing and glass
3:58 Connect the T10 position light with the Angel eyes and the dimmable wire with the + of the low beam (when you turn on the low beam, the angel eyes will dim from DRL to position lights)
4:16 Drill a hole of 22mm in the cap for the rubber and wires
4:31 Put all the wires in the housing and mount the H1 xenon bulb. Connect the two plugs with the original H7 connector
5:01 Clean it a little before you put it back in the car
5:22 Final view, SMD Angel eyes as DRL and position light when you turn on the low beam bi-xenon projectors. Here we use the best XB35 5500K H1 bulbs for a perfect match and perfect light output!
𝗔𝗱𝘃𝗮𝗻𝘁𝗮𝗴𝗲𝘀 𝗼𝗳 𝗮 𝗕𝗶-𝘅𝗲𝗻𝗼𝗻 𝗽𝗿𝗼𝗷𝗲𝗰𝘁𝗼𝗿 𝗿𝗲𝘁𝗿𝗼𝗳𝗶𝘁 𝗸𝗶𝘁:
• Much better light output
• Double high beam (xenon + halogen)
• No glare
• Lower energy consumption (35 watt instead of 55 watt)
• Luxury OEM look
𝗧𝗵𝗶𝘀 𝗸𝗶𝘁 𝘄𝗶𝗹𝗹 𝗳𝗶𝘁 𝗼𝗻:
• Kia Joice (1999 - 2003)
• Kia Carstar (1999 - 2003)
𝗖𝗵𝗲𝗰𝗸 𝗼𝘂𝘁 𝗼𝘂𝗿 𝗻𝗲𝘄 𝗙𝗮𝗰𝗲𝗯𝗼𝗼𝗸 𝗴𝗿𝗼𝘂𝗽:
/ europeanheadlightcommu...
𝗙𝗶𝗻𝗱 𝘂𝘀 𝗼𝗻:
Facebook: / retrofitlab
Messenger: www.m.me/Retrofitlab/
Instagram: / retrofitlab.com_official
Our website: www.retrofitlab.com/
𝗢𝘂𝗿 𝗦𝘁𝗼𝗿𝘆:
Retrofitting refers to the addition of new technology or features to older systems. These days there are a lot of people who put a simple plug & play xenon kit in their halogen headlight housing in an attempt to improve night vision and looks of their vehicle. In fact they don’t realize that their headlight beams are often worse than before. Night vision achieves relatively little improvement on night vision because of a poor beam pattern, which increases the blinding of other road users. This is because their headlight housings are designed for halogen and not xenon.
A true Bi-Xenon projector update is now possible for your car. Such an upgrade will significantly improve your light output from 700-2100 lumens to 2800 and 3500 lumens, without blinding other traffic with glare from your headlight. Upgrade your headlight OEM style!
The latest high power Led bulbs will upgrade both the exterior and interior lighting system of your car. Led lighting is becoming more and more popular in the automotive market for obvious reasons. They have longer lifetime, use less energy and improve safety with their fast response time.
Do you have any questions? Do not hesitate to contact us, we are happy to help you out!
Good luck with your retrofit!
These products are not ECE-approved and must not be used on public roads in any exterior application. Use on public roads will invalidate both the operating license and insurance coverage.
#Kia #Joice #Aharon #Retrofit #DIY #Upgrade #Headlight #lighting #HID
#Retrofit #LED #custom #improvement - Авто та транспорт
Great video. Unlike a lot of these self help videos, where they talk a lot of smack for 3/4 of the video, this is to the point
Nice guys keep it up
Good Job bro 👍👍
Muchas gracias.
The rubber that seals the hole in the cap comes with the kit?
Superb bro
Thanks!
Hello as I do to install the lights in the angel kia k5 that was what I wanted to know
Can you change the bulb if it goes bad later? Or you have to take the headlight apart?
do you bi xenon and angel eye for kia picanto morning?
size of angel eye?
How i install in k5 angel light led
Hi, super work. Please, tell me 2:53 rubber's (or glue) name. How can İ find it?
Special headlight butyl :-) www.retrofitlab.com/en/butyl-rubber-sealant.html
@@Retrofitlab thanks 😏
Does opening the headlight case will cause a moisture? Thanks!
***** Thanks u failed to seal it properly:)
Just kidding, i mean thanks for the answer. I know u did it well.
what is the exact name of the glue you use to re-stick the headlight
thanks a lot because every time i wash my car water seeps into my headlight causing them to fog up i hope this sealant is close to the factory one. And do u have any idea how to remove the old sealant
What is the kind of 'glue' or silicone that you use, please? I would like to do the same with my seat ibiza cupra 2002. Best regards.
We use special headlight butyl;
www.retrofitlab.com/en/butyl-rubber-sealant.html
Love the work🔥🔥 what’s that sort of silicone you applied between the headlight clear lens cover and rear cover?
This is a butyl sealing: retrofitlab.com/products/butyl-rubber-sealant?_pos=1&_sid=8f8d38087&_ss=r
pls co to je za lepeni v minute 3:07 to je silikon ? nebo lepidlo ?
Jedná se o speciální butylové světlomety, speciálně používané pro těsnění světlometů. www.retrofitlab.com/en/accessories/butyl-rubber-sealant.html
para un kia rio 2016 sedan que me aconsejan ?
usa bulbo H4
I would suggest to use the Mini H1 Twin Kit: www.retrofitlab.com/en/hid-projector-kit/bi-xenon-mini-h1-twin-kit-1.html
How to avoid moisture i did it on my headlight installed drl but one headlight started absorbing moisture do i have to reopen and do it
Using butyl to seal it / a good seal is most important. But it also needs to ventilate, with these vents you can optimize the ventilation (to let the damp air out). www.retrofitlab.com/breathing-vents.html
Hi I have a Mitsubishi Magna 2003 I want to ride lenses of any type installed
Thank you
GOOD JOB WOULD YOU LIKE TO SEE IN THE LIGHTHOUSE MEGANE GRANDTOUR HOW WOULD . THANK YOU .
ok
How do you align the projectors
Make sure to mark the cut-off of the stock halogen headlights on a wall, before you install the projectors.
Can this fit on my 2013 Nissan note ?
Yes, this is possible! :)
Need a kit like that for a Nissan N15 model...
Sorry, no specific kit for it. Probably the Mini H1 with the mini gatlin shroud would fit :)
Could you tell what heat setting are you using for heating the box?
e use a setting of 300 Degrees Celsius for 12-18 minutes / 1st lowest setting, depending on the size of the headlight.
@@Retrofitlab Thx a lot!, what about angel eyes, they are known to have short life, do you know how to prevent them from burning out?
@@hadam96 Usually with good quality LED ones there are not a lot of problems. Sometimes the driver fail, but they are usually easy to replace and under warranty.
Ziet er niet super moeilijk uit.. Maar hoe groot is de kans dat die lek gaat? Als je dit zelf doet kost veel meer tijd dan laat doen..
+Retrofitlab begrijp ik. Heb via Ali express drl verlichting gezien. Heb een Astra h met "angel eyes" zonder drl en gewoon 4 ledjes per oog. Enige min punt is. Dat enkele ledjes binnen 3-4 maanden doorbranden. En elk jaar met apk open moet doen. Ben er klaar mee 😁. Dacht dat zo'n vervanging te doen moet zijn..
You are the best. do you bi xenon and angel eye for kia spectra 2009?
Kia joice sol ön far sol arka stop lambası lazim bana varsa cikma veya sifir
15 minuti di tempo per far riscaldare il faro per aprirlo, ma a quanti gradi?....80°,100°,150°
quindi, 15 minuti per gradi...?
grazie
Preheat the oven at 200 degrees Celsius. When ready, switch off the oven and place the headlight inside. Make sure that the headlight is not touching any metal of the oven by placing a cloth over the grid, for example. Leave the headlight in the oven for 10-15 minutes before opening it. If the headlight kit is not yet soft enough, put the headlight in the oven for a bit more time.
polo 9n?
www.retrofitlab.com/en/volkswagen-polo-9n-2002-2005-bi-xenon-mh1-halogen-headlights-1.html
Why mori ❓❓
?? What do you mean :)
I am the manufacturer of car lights from china , our main product is LED&Laser projector for car lighting upgrade and also customize the lighting based on your requst. if you are intereted I can send you more infromation about laser projector , I believe our laser projector can sell well.may I have chance to do business with you