Fusion 360: Project to Surface

I hope you enjoyed this video.
Don't forget to "Subscribe", "Like" and hit the "Bell" icon to be notified when the next video is out!
***************
Cheers : )#Fusion360NewbiesPlus, #Fusion360

[@ikbo]

In your example "Project to surface -> Spit face --> Offset face" is a better solution to "Extrude from object"

[@robertofalorni7439]

you were the only one that explained so that i was able to make it work

[@Fusion360NewbiesPlus]

I'm glad I could help 👍

[@owenbarnes7186]

same

[@potatofries144]

I get an error, "Error: Cannot extend extrusion to object. The extrusion profile falls outside the boundary of the selected body. Select a face or plane instead, or adjust the profile so that it falls inside the boundary of the selected body."

[@qcnck2776]

Thanks for showing how project wont work for 3D. The extrude command will get the letters on the 3D surface. But I believe the letters will not wrap around the curved surface correctly... they will be stretched out sideways.

[@Fusion360NewbiesPlus]

You are right!
Wrapping is a whole different story. For that, you will have to use the Sheet Metal and that also has some limitations Or there is another technique for Wrapping, but it depends a lot on exactly what you want to wrap.
If you need help, please let me know.
I think you should ask for this feature in the Idea Station!

[@qcnck2776]

@@Fusion360NewbiesPlus Thanks. Appreciate your series!

[@ikbo]

Correct workflow for that is to project the curve on the surface. Then use the curve to split the face. Then offset the split face. Cumbersome but it get the job done and is accurate compared to the extrude from object which doesn't extrude in the direction of the surface normals.

[@rodrigocristopherpelucchiv2970]

New stuff I learned today, thanks!

[@Fusion360NewbiesPlus]

You bet!

[@Fusion360NewbiesPlus]

And if you need more, you can contact me on my forum: tesreg.com/forums/

[@menmaoi]

Hey... I cannot project my curve because fusion give error to me like: Warning: Not support projecting sketch geometry into same sketch, please change the target sketch or geometry. Can u help me?

[@sakenkabyshev7175]

After choosing the project direction, thre is a message "Failed to project the selected geometries". How can it be solved?

[@moibel4420]

Thks a lot Bro..

[@Fusion360NewbiesPlus]

You're welcome!

[@Fusion360NewbiesPlus]

And don't forget, if you need more, you can contact me on my forum: tesreg.com/forums/

[@Lenny467]

clear explanation! thanks

[@Fusion360NewbiesPlus]

Glad it was helpful!

[@mrbigheart]

genius!

[@crossthreadaeroindustries8554]

Thank you for the share. What is project used for, if not this? I learned about the extrude-from-surface from this vid.

[@Fusion360NewbiesPlus]

I'm glad I could help! 👍