He drilled an extra hole for a stud and the anchors. And he will pull it down to run the duct and cut the hole. If you listen to him he said this video was just for hanging. Not a video about duct work. If you don’t like the video don’t watch it. Keep your opinion to yourself. These range holds also are self venting. So you don’t have to put duct in. Watch it a second time. Take notes this time.
This type of hood can be installed exhausted outdoor or indoors with the canister filters I did cut a hole at the top of the hood where it meets the ceiling
@@djjoydeep1194 you can either install the filters or the exhaust pipe like I did in this video ua-cam.com/video/tDzsOKYaflg/v-deo.htmlsi=R_nxOz6qTYDKWfQV
Can i install in twin duplex 2 kitchen cooker hood exhaust ducts into 1 no of already laid 100mm conduit pipe. That is 2 hood exhaust sending fume out through only 1 100mm pipe
@@amsterdamtypewriter6410 this model has the option to use a charcoal canister filter to clean the air then it blows back into the room, but i did install the vent tube afterwards in this video ua-cam.com/video/tDzsOKYaflg/v-deo.htmlsi=gRfJiK8yq6dAeOeF
Moved into a new home. Noticed that the paint by the side of the rangehood is peeling/staining +- small cracks emerging around joint lines. There is silicone/sealant on the edges of the rangehood, which seems to be deteriorating/having gaps. Is air escaping and this is causing the issues? Do I just need to reseal it with more sealant? Is sealant use normal when installing rangehoods?
Lots of great physical installation pointers BUT.....according to the 2020 NFPA-70E code, Article 422.16 (4)(4) requires the receptacle supplying power to be "accessible", on a separate circuit and the cord length can only be a minimum of 18" up to a maximum of 48". Seems most manufacturers fail to address this electrical power requirement.
Awesome video. You think Cosmo would have one. I have a higher ceiling and I’m having trouble finding extensions to bring the ducting higher. Gonna try calling them
I can't imagine doing this before the vent duct is through the ceiling. Don't know how he's getting suction with the vent going nowhere. I also can't imagine anyone anchoring to drywall. I don't want to be critical, but saying you don't have to find or install studs to anchor to the wall is just plain wrong.
I hooked up the vent right after installing the hood I'll include a link to that video and as far as studs the directions auctully state no studs are needed to anchor but I anchord to the studs anyways for far better support cause just drywall I can see falling off the wall after daily use. ua-cam.com/video/tDzsOKYaflg/v-deo.html
Finding studs for the decorative Duct is a waste of time unless the wall is already open and you can reframe it. The main unit he placed the weight bearing part into the studs (top bracket for the unit to hang from).
Who cooks that much stinky stuff ? Just vent inside for as little cooking most of us do nowadays . Venting outside is expensive and maintenance is a pain .
Thank you for a no nonsense explanation with no unnecessary music, excellent video! 👍
Thank you and your welcome
would have been better with a 20-piece orchestra synced to the emotional highs and lows of installation victory & defeat
Agreed. I hate the music and time wasting.
1000 times more helpful than the instructions that came with the Everdure Rangehood.
Thank you I'm glad it help
Thank you. Very clear. I installed my range hood by myself, these videos are a great help for single mums!
He drilled an extra hole for a stud and the anchors. And he will pull it down to run the duct and cut the hole. If you listen to him he said this video was just for hanging. Not a video about duct work. If you don’t like the video don’t watch it. Keep your opinion to yourself. These range holds also are self venting. So you don’t have to put duct in. Watch it a second time. Take notes this time.
Very clear? What??
This is a how Not to do it video
This is the EXACT video I have been searching for. Thank you so much
very good video if I run it ductless does the outlet have to
be outside the duct
This is a ductless or duct range hood why do have to run duct vent out just have a filter
Just asking ?
Nice video it was much easier to follow then the Chinese/English installation instructions 😅
Where's the whole for the exhausted, I'm confused
This type of hood can be installed exhausted outdoor or indoors with the canister filters I did cut a hole at the top of the hood where it meets the ceiling
Any thoughts on a flange that goes around the square housing at the top to cover space? Similar to crown molding? Something simple, please?
Hi. Is it ok/safe to leave the outlet/plug behind the vent ?
That's how mine is setup and was told by the building inspector that it is acceptable
Hi, what happened with the smoke? Where that smoke going? You not supposed to lead the smoke out from the wall chemeny?
@@djjoydeep1194 you can either install the filters or the exhaust pipe like I did in this video ua-cam.com/video/tDzsOKYaflg/v-deo.htmlsi=R_nxOz6qTYDKWfQV
Its a gorgeous wall mounted piece of work ❤
It sure is
You saved me $200.
Thanks so much Mate🙏
You are welcome
Can i install in twin duplex 2 kitchen cooker hood exhaust ducts into 1 no of already laid 100mm conduit pipe.
That is 2 hood exhaust sending fume out through only 1 100mm pipe
Did your chimney go all the way to the ceiling?
@@Johnyboyknowsbetter no it's at the top of the hood, I ended up running a tube up through the ceiling and to the outdoors
Could I cut the cord and just hard wire the vent ? I have the cables from previous vent but new vent has a plug
Yes absolutely
Exactly what I need. Thanks.
Excellent install, but would like to see the whole deal with the exhaust leading to the outside....Thank you
I made a separate video showing what I did ua-cam.com/video/tDzsOKYaflg/v-deo.html
Thanks for the great simple install video.
Your welcome
What if you don't want to run the duck outside? Will the fan work as good?
If you don’t want to vent the fan to the outside you’ll need a ductless exhaust fan.
Where does the exhaust air go?
@@amsterdamtypewriter6410 this model has the option to use a charcoal canister filter to clean the air then it blows back into the room, but i did install the vent tube afterwards in this video ua-cam.com/video/tDzsOKYaflg/v-deo.htmlsi=gRfJiK8yq6dAeOeF
Got the same one, why is mine tipping down a bit, its not straight
Great explanation but aren’t you putting backsplash in you kitchen ?
Yes I did
Excellent video!! Thanks !
Moved into a new home. Noticed that the paint by the side of the rangehood is peeling/staining +- small cracks emerging around joint lines. There is silicone/sealant on the edges of the rangehood, which seems to be deteriorating/having gaps. Is air escaping and this is causing the issues? Do I just need to reseal it with more sealant? Is sealant use normal when installing rangehoods?
Not sure why someone would use silicone
Hi if a motor is broken is it reasonable to replace the motor only or change the hood completely ??
You can replace the motor I had to replace one once and used a motor from a bathroom exhaust fan
Lots of great physical installation pointers BUT.....according to the 2020 NFPA-70E code, Article 422.16 (4)(4) requires the receptacle supplying power to be "accessible", on a separate circuit and the cord length can only be a minimum of 18" up to a maximum of 48". Seems most manufacturers fail to address this electrical power requirement.
Shut up boomer
This qualifies as accessible.
Where do you cut the hole next so it go outside?
I show what i did in this video ua-cam.com/video/tDzsOKYaflg/v-deo.htmlsi=-MvgFj0xqLCpvouR
Is this okay to be ductless, any problems?
I did run a duct to the outside but you can buy a charcoal filter for this model and can be run ductless
What is the stud finder that you used?
Some weird brand called sapphire it came from Sam's club
Could you link to this product? Or specify the model to buy in stores?
I bought it off Amazon here is a link a.co/d/7xUA4g7
What is the height from the kitchen to the bottom of the range hood? Thanks.
I went with 26 inches
@@jlistdiy Thanks for the nice video. Is there a min and max distance requirement to ensure the optimal venting efficiency? Thanks.
@@liangmaew yes their is and it it depends on which hood you purchase the recommended clearance will be in the directions
How the heat we go outside
I made a video showing how I vented it to the outside ua-cam.com/video/tDzsOKYaflg/v-deo.htmlsi=aO6OZp72-lxeBoC9
Very helpful and straight forward thank you 💙
Your welcome I'm glad it helped
really nice detailed and straight-to-the-point video, thanks.
Thank you and your welcome
bro where are you venting it too?
I vented it outdoors here is a video link of how I did that ua-cam.com/video/tDzsOKYaflg/v-deo.html
Awesome video. You think Cosmo would have one. I have a higher ceiling and I’m having trouble finding extensions to bring the ducting higher. Gonna try calling them
Thank you and Yeah definitely give them a call and see if they have a extension kit
Cosmo does have one: ua-cam.com/video/gJ4KTSptaSE/v-deo.html
These don’t require to vent out. Filter traps all u need to clean filters about once a week
Fantastic 101 instructions. I installed it with ease using your instructions. That blue paper was aweful. 😊
Thanks
Awsome I'm glad it helped and yes the blue stuff was definitely a pain to remove
Are you gonna have a video when you finish the venting?
I did start running the vent already but I could make a video showing what I did if that would help in any way
@@jlistdiy that would be great
I hope this helps ua-cam.com/video/tDzsOKYaflg/v-deo.html
Very nice❤
Thank you
Remember there has to be a duct to take out the exhausted air which is not covered here.
Your are correct I did show how I did that ua-cam.com/video/tDzsOKYaflg/v-deo.htmlsi=pREB3anAKfhqvXTTin this video
Looks good
Thank you
Great job
Thank you
Did the anger come along with it
Yes the hanger came with it
I can't imagine doing this before the vent duct is through the ceiling. Don't know how he's getting suction with the vent going nowhere. I also can't imagine anyone anchoring to drywall. I don't want to be critical, but saying you don't have to find or install studs to anchor to the wall is just plain wrong.
I hooked up the vent right after installing the hood I'll include a link to that video and as far as studs the directions auctully state no studs are needed to anchor but I anchord to the studs anyways for far better support cause just drywall I can see falling off the wall after daily use. ua-cam.com/video/tDzsOKYaflg/v-deo.html
These are light. Probably the weight as your arm
Some people recirculate the air using carbon filters with no vent
Some of these come with carbon filters as an option to not vent and these things are relatively light l, like others mentioned
Finding studs for the decorative Duct is a waste of time unless the wall is already open and you can reframe it. The main unit he placed the weight bearing part into the studs (top bracket for the unit to hang from).
MUY BUENO SOLO Q EL MÍO TRAY UN DESORDEN CON EL CABLEADO DE ELECTRICIDAD YA AVÍAN AVIERTO LA CAJA
Perfect
Thanks
I won't lie. I was expecting bro to find the 14-2 cable in the wall below that plug.
I wish I do not have to open the wall or run any pipe
165 Boyle Mall
804 Larson Square
DUDE WHERES THE VENT OUTSIDE???😂😂😂 where is blowing out the air????
I show that here in this video ua-cam.com/video/tDzsOKYaflg/v-deo.htmlsi=Vi_1xT0VpPOCABXB
The most difficult thing by far on these hood vents is removing the plastic 🤣
Omg yes so true lol
Looks like a fish and chip shop 😂
😆
🤷 no duct, wast of time.
@@paullgagliardi5798 I showed how I duct it to the outside in this video ua-cam.com/video/tDzsOKYaflg/v-deo.htmlsi=WX7GJTZCe9naCtJf
Who cooks that much stinky stuff ? Just vent inside for as little cooking most of us do nowadays .
Venting outside is expensive and maintenance is a pain .
Nice and easy
3596 Devante Walks
Where is your duct?
@@vrado441 I showed that in this video ua-cam.com/video/tDzsOKYaflg/v-deo.htmlsi=HFufaEczZINIeqrk
@@jlistdiy ductless fans are useless
6587 Roberta Pass
7673 Tiffany Prairie
07832 Nikko Mills
5392 Jakubowski Motorway
Great job
Thank you