@@MeadowgateWorkshaving trouble finding that bar here in Australia I can find a holtzfforma and other brands in the same spec to fit HUSQVARNA 36 41 50 51 55 336 340 345 350 351 353 346XP 435 440 445 450 455 460
If you need a video I don’t have the chainsaw but I can try to get one and make a video, also I will try to find a fuel tank diagram and send it to you then basically follow below or it should be very similar to other 1 series Husqvarna chainsaws. You have 2 lines that go in the tank. One has a filter on it in the tank fish the line out with the filter and pull off the filter then disconnect from carb and pull the line out. 2nd line goes from the bulb to the tank, pull line of the bulb then pull out of the tank. Note how much lines were protruding into the tank so you can have it the same when you put new ones in. Cut new lines to length and push them back in. Not easy sometimes it’s a tight fit.
looklike it run good i just bought 120 mark 2 before i even run it doing a muffler mod
Pouvez-vous m'expliquer à quoi servent les cales en plastique dans le cylindre
Hi good work getting that saw up and running again
I too have a 120 and want to put a 20" bar
Do you have a part number for that sprocket?
@@dalewhitmore143
From Amazon:
CSCTEK .325 7T 7 Teeth Clutch Sprocket Drum Bearing Kit for Husqvarna 137 136 141 142 36 41 235 236 240 235E 236E 240E Chainsaw #530014949,530069342 (325-7T-137)
@@dalewhitmore143
a.co/d/0abYiJPV
Thanks very much
@@MeadowgateWorkshaving trouble finding that bar here in Australia
I can find a holtzfforma and other brands in the same spec to fit HUSQVARNA 36 41 50 51 55 336 340 345 350 351 353 346XP 435 440 445 450 455 460
ma stavi šipku od 2 metra kakve budale ima
How do I remove fell lines on A husky 120 mark-1 chainsaw
If you need a video I don’t have the chainsaw but I can try to get one and make a video, also I will try to find a fuel tank diagram and send it to you then basically follow below or it should be very similar to other 1 series Husqvarna chainsaws.
You have 2 lines that go in the tank. One has a filter on it in the tank fish the line out with the filter and pull off the filter then disconnect from carb and pull the line out. 2nd line goes from the bulb to the tank, pull line of the bulb then pull out of the tank. Note how much lines were protruding into the tank so you can have it the same when you put new ones in. Cut new lines to length and push them back in. Not easy sometimes it’s a tight fit.