Making and S-Bend in 1-1/2" PVC Pipe for a drain using heat

I've been working on the messed-up plumbing in our house for a coupla months now and I am finally getting it dialed. It's been so long because I have a lot of other stuff going on in my life, not just plumbing!
I needed to link up two fittings that are 5" offset horizontally and about 30" apart vertically, so I needed an 'S-bend'.
In this video I use a heat gun and the sliding table on my table saw to assist in making the bend so that the centerlines of the two ends of the bent piece are parallel.