Would a fault in the rams cause the vehicle to have a drop on the drivers side, mines doesn't sit level, it has airbags which I don't think leak and it's not got a broken spring 🤔
Believe it or not the front springs are handed left to right , I’ve heard if you swap the front springs left to right it can cure it Also check your rear height sensors are both reading the same height If they’re off it may be under inflating /over inflating one side
I’m on with the same job. Have you noticed any drone noise since you did this. I ask because apparently there is an attenuator in the high pressure line from pump to actuator, which you would have removed with your new pipe. Cheers 👍
Yes I too have a drone , I looked at the old pipe in detail and couldn't find anything , however the original has a short section of a large diameter which could possibly be for reduction of noise I'm getting used to the drone so at the moment I'm just pleased it's not leaking 😀
Finally the best mechanic is the owner of disco…!!!
Would a fault in the rams cause the vehicle to have a drop on the drivers side, mines doesn't sit level, it has airbags which I don't think leak and it's not got a broken spring 🤔
Believe it or not the front springs are handed left to right , I’ve heard if you swap the front springs left to right it can cure it
Also check your rear height sensors are both reading the same height
If they’re off it may be under inflating /over inflating one side
This would’ve been a really good tutorial, however; WHY add the loud music drowning any voice out🙃
you should use a genuine hose for the high pressure pump to valve block or you will get a horrible noise
Yer I found this , but for now it keeps the vehicle up and running
I’m on with the same job.
Have you noticed any drone noise since you did this. I ask because apparently there is an attenuator in the high pressure line from pump to actuator, which you would have removed with your new pipe.
Cheers 👍
Yes I too have a drone , I looked at the old pipe in detail and couldn't find anything , however the original has a short section of a large diameter which could possibly be for reduction of noise
I'm getting used to the drone so at the moment I'm just pleased it's not leaking 😀