I only ran it for a few seconds for my friend to see it run. The motor can’t jump off the studs so I knew it wasn’t going anywhere. I should have taken the drill and stuff off of the stand. 😂
I can’t remember the exact length but they were smaller than the stock ones. They were about the size of a gx160 pushrod. They sell a tool to help with that and get cut-to-length pushrods
Stock or aftermarket cam? .003 for aftermarket cam I believe since that’s the only setting that i have ever seen except for stock setting. The cam determines the valve lash valve lash spec. Not the head. 27/25 & 32/28mm is referring to the size of valve face and size hole that it sits in
Bolt it down … sheesh
I only ran it for a few seconds for my friend to see it run. The motor can’t jump off the studs so I knew it wasn’t going anywhere. I should have taken the drill and stuff off of the stand. 😂
that demon engine is going to over heat and seize. it has no air intake on the flywheel cover. might wanna take that silver cover off...
Think bout puttin one on my minibike
Straight nasty
Like the build bro good shii. Take the filter off the carb so it stop idling like dat and prolly need a bit smaller jet 🌚🫡
What valve springs
Nice build!
Thanks!
@@dr.minibikemr.gokart6602 do you know how much hp us the motor?
@@dezmonseth674 It was over 20hp but I didn’t dyno it. Buyer in Cali told me after he got it.
@@dr.minibikemr.gokart6602 Wow! That's impressive! I just bought a stage 3 kit for my Honda GX 200.
Hey, what jets are you using for the pilot and the main? I can’t get mine to idle properly.
Dual
Niice😤
What valve springs are you running and did you upgrade the pushrods
#42 dual springs (for sure) and OEM Honda GX160 or GX200 pushrods (I think)
how much hp is this, and how much does this cost
what size pushrods do you use with a 356 cam and 1.2 ratio roller rockers im running a non hemi big valve head
I can’t remember the exact length but they were smaller than the stock ones. They were about the size of a gx160 pushrod. They sell a tool to help with that and get cut-to-length pushrods
@@dr.minibikemr.gokart6602 thank you
@@ChristopherAdamDelong you’re welcome
whats the valve lash sit on i have the 27-25 thinking about buying that one as wel
@@dr.minibikemr.gokart6602 currently im looking into some not shure which one woukd be good
Stock or aftermarket cam? .003 for aftermarket cam I believe since that’s the only setting that i have ever seen except for stock setting. The cam determines the valve lash valve lash spec. Not the head. 27/25 & 32/28mm is referring to the size of valve face and size hole that it sits in
@@509minibikes it depends on what you got and trying to do. I’ve seen people claim that smaller works just as good as as 32/28mm. I like bigger
No flywheel lol
Who needs bolts anyways? 🤷♂️
How it run on kart
This went on a mini bike. And it was strong