Hey buddy I put some Taylor wires on a BBC back in '99! You just brought back the thought, for the life of me I don't recall how I did it..... I do remember that I don't buy those anymore! lol Good to see ya!!
That's my thought as well...I have moroso cut to fit wires and have them already cut and crimped with fittings till I ran out of sunlight....well see what tomarrow brings
Thankyou for this tip! Helped get my 90° boot on, but now it's stuck flush with the end, and I need to get alittke more out to crimp, and push back in..
hello, i just installed them on my v8 engine and the grey boots are straight and are touching the headers, will that be a problem? also, can you bend the straight boots to be in angle?
In my experience, if the boots are touching the headers it is always going to be a problem. The boot can’t be bent, you have to buy angled boots. I have seen them available in 45° at 90° bends.
![How To Perform a Compression Test - [EASY]](http://i.ytimg.com/vi/3VmmL0YAO14/mqdefault.jpg)
This is extremely helpful! Now I may actually be able to get my boat out on the water. 😂
Thanks for your help! My husband has been tearing his hair out over this process!
Dish soap and a small screwdriver always does the trick for me.
Hey buddy I put some Taylor wires on a BBC back in '99!
You just brought back the thought, for the life of me I don't recall how I did it.....
I do remember that I don't buy those anymore! lol
Good to see ya!!
I can’t remember if I’ve ever done these before, but if I have it’s been at least 40 years ago!
10/10 exactly where I was getting stuck
You the man! Great tip.
Appreciate it!
Why wouldn't you crimp the ends first then push it through...the fitting is just a straight fitting anyway
It’s making a 90 degree turn inside the boot
If your going to pull it back into the boot why bother...? Just crimp it and push it in....???
The after market boots are too tight and not flexible enough for that. I ended up re using the stock GM boots that I luckily hadn't thrown away.
Good to know
That's my thought as well...I have moroso cut to fit wires and have them already cut and crimped with fittings till I ran out of sunlight....well see what tomarrow brings
Thankyou for this tip! Helped get my 90° boot on, but now it's stuck flush with the end, and I need to get alittke more out to crimp, and push back in..
You can use a pick to lift the edge of the boot and squirt some penetrating oil in there to get it to slide a little easier.
hello, i just installed them on my v8 engine and the grey boots are straight and are touching the headers, will that be a problem? also, can you bend the straight boots to be in angle?
In my experience, if the boots are touching the headers it is always going to be a problem. The boot can’t be bent, you have to buy angled boots. I have seen them available in 45° at 90° bends.
@@pinkcaddygarage267 i have read that msd boots are bendable. Are you sure?
I have not tried the MSD wire so you may be right about that. The ones I have tried in the past were not bendable.