Thank you so much for this video. I just bought one just like this and broke the round top of the screw trying to untighten it. Who knew I just needed to untighten the wing nut and then slide it down...smh
3 Keyhole slots - place heads on pegs through round holes and adjust each half of split cylinder so shafts of pegs slide into slot portion of tabs. 4th attachment is slot for shaft of wingnut, which, when tightened, holds the baffle cylinder together. Use a tall pole so the squirrel cannot jump (can jump vertically 4 feet) straight to feeder.
Thank you so much for this video. I just bought one just like this and broke the round top of the screw trying to untighten it. Who knew I just needed to untighten the wing nut and then slide it down...smh
I hope it keeps the little buggers off of your Bird Seed. Keep us updated. 👍🤞
thank youuuuuuu
Assume this type baffle will fit on any type metal pole?
Yes, watch the video & I explain it further. 🤞👍
I can’t separate the two sides. Any suggestions? Thank you.
There is slots & pegs that notch together to attach both halves. 🤞👍
Pull up after loosening the wingnut. Took me a while to figure out.
3 Keyhole slots - place heads on pegs through round holes and adjust each half of split cylinder so shafts of pegs slide into slot portion of tabs. 4th attachment is slot for shaft of wingnut, which, when tightened, holds the baffle cylinder together. Use a tall pole so the squirrel cannot jump (can jump vertically 4 feet) straight to feeder.