You guys are great. It's great the way you take care of each other. I see it this way: "In the A-6 Intruder of life, I am the pilot and my wife is the bombnav. I make it go hot, fast and low, and she punches in the coordinates of where we are going." Wouldn't have it any other way.
Finally going to try this with mine. I have watched a dozen videos, all on the 2021 I have heard Ford encoded the GOAT modes differently for the 2022 so I cannot enable them but at least I can get the speedo closer. went from the 32" to 35" and maybe eventually go to 37" Thanks for making it so clear (The vehicle back up file most videos were not clear on)
How about the second part of the programming where you have to deal with the P160A DTC in the AWD module? Caused by mismatched information between modules.
Thanks for the video! I wonder if you're supposed to use the mean usable tread as circumference rather than full/new tread. It would been more accurate that way since the tire loses circumference over time.
We got a power train fault / 4x4 drive fault after changing the tire size. However, people have gotten it for no reason n it also went away on its own too. So idk 🤷🏻♀️
I also got the same 4x4 fault right when I changed my tire size. I was going to revert back to the originally saved profile so I connected to forscan again and clicked "yes" when asked if I wanted to load a previous profile, but it just ended there and nothing changed. Any thoughts?
there have been people on different forums who said they suddenly got the fault with no forscan anything done - and it went away on their own. we still have our fault on the screen lol waiting for it to go away but I think we may have to pay a couple hundred bucks to have the dealership clear it. idk to b honest. check out the forums - bronco nation and bronco6g (where we originally found it some months back)
Lol nope! We still have that beautiful warning light on the dash lol even after the ForScan …battery disconnect didn’t. We put the aux switches in and disconnected the battery because we had to install the new fuse box, still there.
Don't know if you got the answer to the issue, but I had the same thing last night. After inputting the new circumference, you need to go do a relearn in the AWD module. The 4x4 issue will go away after running that.
For 2022 Rotopax now makes a medium gray Maxtrax ( traction board ). I'm guessing due to the volume of 2021 & 2022 Cactus Grey B.S. & Broncos sold & ordered
If the sasquatch circumeference of 2653mm got you to 68.9mph and the vehicle read 70mph, then you would need to change that 2653 to ~2695mm. (68.9/70)=(2653/x)
Soooo how many functions does ForScan do ? I know it shuts off annoying buzzers & alarms. Is it around 100 $ too ? like the stop the auto stop ( fuel ). If I had a Bronco on order I'd buy 1 of each gizmo.
This will give you a laugh. ARB Tred Pro has made a 2022 Limited Production traction board in SAND TAN. There's a V.G. reason why TB's, Kinetic Ropes, Tow Straps, Ratchet Straps are normally RED, Blaze Orange, Lime Green, Canary Yellow, Royal Blue.
Well I won’t see it when you post it since I will be working but I will catch it when I can! Congrats! Hope mine does not get pushed any further back on build date.
So I've heard it said recently that tapping into the computer on your vehicle with Forscan automatically sends a message to Ford motor company and that they can and will void warranties over certain modifications. Anything more to share about this?
I believe the comment was made in a reply to a comment made at the T&C TV UA-cam channel site and that the reply was from T&C Ford. I'm trying to find it again, but was struck by the degree of connectedness/trackability being "baked into" cars these days. While I'm sure there are advantages, but I'm also concerned about the potential intrusion on privacy and potential hacking that may come with it.
The law requires a warranty provider prove a modification caused the issue under claim. They can't void a warranty outright. However, and this is part is speculation. A bigger tire could cause an issue and they could use that to deny a claim.
I took my bronco to the dealership , they used forscan to change the tire size, but i lost my cruise control as a result. Brought it back to my for dealership and since they could not figure it out, they restored the original computer setting and refunded me, leaving my computer set for 32 inch stock wheels. Has anyone else lost cruise control after the tire size change ?
We have not, but we have a 4x4 fault. However, bronco6g forums said ppl have had the same fault we do and they never used forscan but it eventually went away on its own so I really don’t know if this one will vanish or if I need to clear it.
@@1Five1Garage no no, it's not a joke. You take the OD and multiply it by .967 and that compensates for the squish factor of the tire's flat contact patch. My f150 has 275/65/20 with a 2718mm OD. 2718mm x .967 = 2628mm, put 2628mm in forscan and my speedometer is accurate.
Jill - You are wonderful. Thank you for the training.
You are so welcome!
You guys are great. It's great the way you take care of each other. I see it this way: "In the A-6 Intruder of life, I am the pilot and my wife is the bombnav. I make it go hot, fast and low, and she punches in the coordinates of where we are going." Wouldn't have it any other way.
This is great. Works for 2021 and up f150 as well. Thank you so much for posting.
You’re welcome!
Finally going to try this with mine. I have watched a dozen videos, all on the 2021 I have heard Ford encoded the GOAT modes differently for the 2022 so I cannot enable them but at least I can get the speedo closer. went from the 32" to 35" and maybe eventually go to 37" Thanks for making it so clear (The vehicle back up file most videos were not clear on)
hmm - we do not have a 22 to try and forscan on it to enable all 8 modes.... You may need to check out the forums. Check Bronco Nation or Bronco6g
@@1Five1Garage Quick question, when reconfiguring tire size, do you have the key on/engine off, or key on/engine running?
Great work Jill
Thank you!
Jill you doing a great job on the videos keep it up
Thank you so much!
How about the second part of the programming where you have to deal with the P160A DTC in the AWD module? Caused by mismatched information between modules.
youhave to relearn pcm to clear the DTC errors
Thanks for the video!
I wonder if you're supposed to use the mean usable tread as circumference rather than full/new tread. It would been more accurate that way since the tire loses circumference over time.
Even with the correct circumference we still have to adjust the number to correct the Speedo to match gps.
Any issues with relearning the pcm after changing the tyre circumference?
Just been able to relearn the AWD not the pcm and now have DTC
We got a power train fault / 4x4 drive fault after changing the tire size. However, people have gotten it for no reason n it also went away on its own too. So idk 🤷🏻♀️
I also got the same 4x4 fault right when I changed my tire size. I was going to revert back to the originally saved profile so I connected to forscan again and clicked "yes" when asked if I wanted to load a previous profile, but it just ended there and nothing changed. Any thoughts?
there have been people on different forums who said they suddenly got the fault with no forscan anything done - and it went away on their own. we still have our fault on the screen lol waiting for it to go away but I think we may have to pay a couple hundred bucks to have the dealership clear it. idk to b honest. check out the forums - bronco nation and bronco6g (where we originally found it some months back)
is the measurement a straight line on a graph from 0 to 70 mph or is it a curve where it is only accurate at 70 mph and might be say 38 at 35 mph
it's pretty accurate through the power band.
Any updates on the BL,,
Stay tuned. By the end of the week. 😋
Did your 4x4 fault ever go away? Just did the tire size and have the 4x4 fault. Thought about doing a battery disconnect to see if that fixes it.
Lol nope! We still have that beautiful warning light on the dash lol even after the ForScan …battery disconnect didn’t. We put the aux switches in and disconnected the battery because we had to install the new fuse box, still there.
Don't know if you got the answer to the issue, but I had the same thing last night. After inputting the new circumference, you need to go do a relearn in the AWD module. The 4x4 issue will go away after running that.
@@kerinobrien6642how do you do a relearn?
For 2022 Rotopax now makes a medium gray Maxtrax ( traction board ). I'm guessing due to the volume of 2021 & 2022 Cactus Grey B.S. & Broncos sold & ordered
Probably…
If the sasquatch circumeference of 2653mm got you to 68.9mph and the vehicle read 70mph, then you would need to change that 2653 to ~2695mm. (68.9/70)=(2653/x)
I might get in there and change it. it's only a few mph off. thanks for the numbers!
Soooo how many functions does ForScan do ? I know it shuts off annoying buzzers & alarms. Is it around 100 $ too ? like the stop the auto stop ( fuel ). If I had a Bronco on order I'd buy 1 of each gizmo.
The switch one was less than $30 the switch less or built in is $50
The actual circumference is 2742mm for 315/70 r17 not 2737mm
😘 thank you!
This will give you a laugh. ARB Tred Pro has made a 2022 Limited Production traction board in SAND TAN. There's a V.G. reason why TB's, Kinetic Ropes, Tow Straps, Ratchet Straps are normally RED, Blaze Orange, Lime Green, Canary Yellow, Royal Blue.
Oh my goodness LOL! That’s a quick way to lose them! 🤦🏻♀️
Wait a sec. Jill was that your Bronco that was lost I just saw?!
Could be.
Well I won’t see it when you post it since I will be working but I will catch it when I can! Congrats! Hope mine does not get pushed any further back on build date.
So I've heard it said recently that tapping into the computer on your vehicle with Forscan automatically sends a message to Ford motor company and that they can and will void warranties over certain modifications. Anything more to share about this?
I worked for Ford. That’s new to me because I have never heard of this before.
I believe the comment was made in a reply to a comment made at the T&C TV UA-cam channel site and that the reply was from T&C Ford. I'm trying to find it again, but was struck by the degree of connectedness/trackability being "baked into" cars these days. While I'm sure there are advantages, but I'm also concerned about the potential intrusion on privacy and potential hacking that may come with it.
The law requires a warranty provider prove a modification caused the issue under claim. They can't void a warranty outright.
However, and this is part is speculation. A bigger tire could cause an issue and they could use that to deny a claim.
This is for Diesel"s parents : Check out 4Knines products. Ray Allen & WeatherTech Pet also.
Will do thanks!
I took my bronco to the dealership , they used forscan to change the tire size, but i lost my cruise control as a result. Brought it back to my for dealership and since they could not figure it out, they restored the original computer setting and refunded me, leaving my computer set for 32 inch stock wheels. Has anyone else lost cruise control after the tire size change ?
We have not, but we have a 4x4 fault. However, bronco6g forums said ppl have had the same fault we do and they never used forscan but it eventually went away on its own so I really don’t know if this one will vanish or if I need to clear it.
AAAAHHH, NITTO GOOD CHOICE
We love our Nittos! (Jill)
Squish factor: .967
Lol
@@1Five1Garage no no, it's not a joke. You take the OD and multiply it by .967 and that compensates for the squish factor of the tire's flat contact patch. My f150 has 275/65/20 with a 2718mm OD. 2718mm x .967 = 2628mm, put 2628mm in forscan and my speedometer is accurate.
awesome. thank you for the info! I'll have to write that down.